|
|
Analysis of adherent cells confluency in 2D culture
Bracková, Michaela ; Čmiel, Vratislav (referee) ; Chmelíková, Larisa (advisor)
First part of this semester work dealing with the theoretical description of adherens cells, particularly structure and functions of this cells. Subsequently work is devoted to description of cell culturing, with mention of conditions which are necessary for cell culturing, following by substances which promote cell growth. Last part of theoretical research is concern with microscopy technique that is suitable for studying of adherent cells. Subsequently it is about fluorescence and confocal microscopes. Practical part dealing with cell culturing of adherent cells and the evaluation of realized experiments.
|
|
|
Lubricant film formation in compliant contact
Jaroš, Tomáš ; Čermák, Jan (referee) ; Nečas, David (advisor)
This diploma thesis deals with the study of film formation in compliant contact. Primary attention is dedicated to the influence of the entrainment speed and slide-to-roll ratio (SRR) on the central film thickness. Based on a research study of the available experimental methods, the fluorescence microscopy was used to achieve the aim of the work. Experiments were realized in ball-on-disk configuration. Firstly, a validation of the method was performed where the solid contact of the ceramic ball and the glass disk was analyzed. Since the measured values were in a good agreement with the theoretical prediction, a ball of NBR rubber material, which is commonly used for production of lip seals and o-rings, was subsequently used. The experimental measurements were performed under pure rolling and rolling/sliding conditions when the entrainment speeds varied in the range from 10 to 400 mm / s. A constant load of 0.2 N was applied. The measured data were then compared to the theoretical predictions for compliant contacts. The results showed that the thickness of the lubricating film gradually increases with increasing entrainment speed, which corresponds to theoretical assumption. Against expectations, evident influence of SRR on the film formation has been observed. In the last part of the thesis the measured data are confronted with previously published studies. Finally, some limitations of this study are discussed and recommendations for further improvement of the used experimental method are suggested.
|
|
|
Multiparametric fluorescence spectroscopy
Lacko, Kata ; Venerová, Tereza (referee) ; Mravec, Filip (advisor)
This diploma thesis deals with the possibilities of multiparametric fluorescence spectroscopy, since the main objective of this experiment was to evaluate the possibilities of multiparametric measurements in the fluorescence spectroscopy laboratory. A suitable fluorescence probe was proposed for this type of experiment that shows high sensitivity for pH changes in the environment, SNARF-4F AM, based on a literature research. The fluorophore was dissolved in solutions of different pH and this system was examined using a time-resolved spectrofluorimeter. The method named TRES (time-resolved emission spectra) was used to obtain the emission spectra of the probe and to find the emission maximum. Fluorescence intensity decay measurements as a function of wavelengths allowed to create deconvolution of the emission spectra, which provided information about the fluorescent lifetime and the relative representation of the states of probes in the solution. Later, the probe was dissolved in solutions of different density and pH - this system served for anisotropic measurements, during which the individual correlation-rotational times of the fluorophore were obtained. The obtained results were then used as the basis for multiparametric analysis, which was performed by using a fluorescence correlation microscope and a spectrograph. This combination allows to measure the necessary fluorescence parameters in one step. A standard operating procedure was created for the spectrograph’s control. On the basis of the obtained information the suitability, accuracy and sensitivity of the multiparametric analysis were qualified.
|
|
|
Cell Viability Measurement
Pelc, Pavel ; Janoušek, Oto (referee) ; Čmiel, Vratislav (advisor)
This work discusses the viability of cells. It describes the principle of fluorescence, fluorescent methods, fluorescent microskopy and the method of dyeing of the cells with a special kit that contains calcein AM and ethidium homodimer dyes. Further it describes the program for analysis and evaluation of viability on two different cellular cultures.
|
|
|
Anisotropy techniques in study of cytoplasm
Sýkorová, Kateřina ; Obruča, Stanislav (referee) ; Mravec, Filip (advisor)
The main goal of this thesis was to compare experiments using time-resolved anisotropy and steady-state anisotropy for measuring in bacteria strain Cupriavidus necator. Fluorescent probe for anisotropy imaging was chosen BCECF_AM, which is derivate of fluorescein. Using experiment in system glycerol/water with fluorescein, anisotropy has been verified and calculated molecular hydrodynamic volume of a single fluorescein molecule, which approximately corresponded with real value. By using fluorescence imaging anisotropy microscopy, images and values of average anisotropy in cells were taken. Images of living cells (bacteria) of CN H16 and mutant CN PHB-4 showed differences, mainly in the uniformity of the inside environment.
|
|
|
Use of selected fluorescence techniques to study of yeasts and yeast metabolites
Mikheichyk, Nadzeya ; Skoumalová, Petra (referee) ; Márová, Ivana (advisor)
The scope of thesis was the optimization of methods for the study of yeast and their metabolites using flow cytometry and fluorescence microscopy. Red yeasts are characterized by overproduction of carotenoids and lipids, which are used in food, pharmaceutical and feed industries. Currently, intensive research is being carried on to find appropriate microbiological alternatives for synthesis of these substances. Present thesis is focused on selected yeast genera: Rhodotorula, Sporobolomyces, Cystofilobasidium and strain Phaffia rhodozyma. Yeasts were cultivated on different nutrient media, in which glucose was used as a nutritional source, and also on glycerol and whey as waste material. In two strains - Cystofilobasidium macerans and Rhodotorula mucilaginosa growth characteristics were determined on a synthetic glucose production medium. All studied strains were able to use waste substrates as a source of nutrients. Some of the strains displayed increased production of carotenoids, and, additionally, in some cases also relatively high production of lipids. In classical cultivation in lipid and glucose medium supplemented with vitamins the best production characteristics displayed Rhodotorula glutinisstrain. In glycerol medium the highest amount of carotenoids and lipidic substances produced Sporobolomyces shibatanus strain. Strain Sporobolomyces roseus showed the best production characteristics on whey as the main source of carbon. The results show use of whey and glycerol seems like appropriate option for potential carbon source to cultivate carotenogenic yeasts and production of carotenoids and selected lipidic substances as products with higher added value. Further optimization of nutrient medium on the given substrates is needed for higher production of selected metabolites. Fluorescence microscopy and flow cytometry have proved to be suitable options for determination of the observed metabolites in the cells, their amount and viability.
|
|
|
Analysis of bacrerial cells employing flow cytometry and flurescence microscopy
Müllerová, Lucie ; Mravec, Filip (referee) ; Obruča, Stanislav (advisor)
This thesis focuses on fluorescent analysis of viability and PHA content in bacterial cultures, the main methods of investigation were flow cytometry and fluorescent microscopy. In order to determine viability of C. necator H16, several viability probes were tested, nevertheless, only BacLightTM kit and propidium iodide can be used to estimate portion of viable and live bacterial cell in samples. Further, Acridine orange was used to monitor physiological state of bacterial culture and two hydrophobic probes, Nile Red and BODIPY 493/503, were used to investigate PHA content in bacterial cells. Application of BODIPY 493/503 seems to be promising since this probe does not require permeabilization of bacteria cells and it can be used along with propidium iodide. Furthermore, several fluorophores were tested in the microscopic part. In was found that concentrations used in cytometric analyses were too high for microscopic use. Emission from the SYTO9 fluorophore is seen mainly in the green channel but because of the high concentration some emission was visible in the red channel. Cells stained with BODIPY 493/503 had very high fluorescence intensities when the stain concentration was 10 . At the same time, negative amplitudes of fluorescence were measured in both strains of C. necator, but in case of C. necator H16 that amplitude was much more pronounced. In this strain surprising high concentration of BODIPY stain was observed on the surface of PHB granules. Anisotropy of the fluorophore was nearing 0 which is very surprising.
|
|
|
Analysis of lubricated compliant contact
Dočkal, Kryštof ; Dzimko, Marián (referee) ; Nečas, David (advisor)
This diploma thesis deals with the proposal of methodology for film thickness eva- luation within compliant contacts. With respect to characteristics of such contact pairs, like variable film thickness, high surface roughness, or poor conductivity and reflectivity, the usage of conventional experimental methods is particularly complicated. In present study, an optical method based on the principle of fluo- rescent microscopy was employed in present thesis. An evaluation algorithm in- volving background normalization and calibration of fluorescent intensity to film thickness was created in a form of experimental software. The proposed algori- thm was validated by using elastohydrodynamic contact formed between ceramic ball and glass disc. The measured film thickness was compared with theoretical prediction, while very good agreement of obtained data was observed. Further, a series of experiments with compliant samples was conducted, while the central film thickness was evaluated as a function of mean speed, applied lubricant, ap- plied load and slide-to-roll ratio. The last part of the thesis is focused on results analysis and discussion considering the previously published literature.
|
|
|
Fluorescence imaging techniques in multimodal holographic microscope
Vašíček, David ; Procházková, Jana (referee) ; Čolláková, Jana (advisor)
The diploma thesis deals with the registration of images taken with the multimodal holographic microscope (MHM). The summary covers the fluorescent and holographic microscopy, and the multimodal holographic microscope combining both these microscopy types. Every pair of the images needs to be aligned in order to gain new information by combining both image types. The thesis contains an algorithm that registers images by phase correlation as well as a process created in MATLAB in accordance with the algorithm. The most important procedure parameters’ influence on the registration success is described and the results are annotated.
|
|
|
Study of fluorescence lifetime and spectral changes of nanoparticles in cell biology
Pelc, Pavel ; Janoušek, Oto (referee) ; Čmiel, Vratislav (advisor)
This work deals with the study of fluorescence lifetime and spectral changes of nanoparticles in cell biology. It describes the principle of fluorescence, fluorescence microscopy and laser confocal microscope Leica TCS SP8. The classic FLIM method, the Lambda Square mapping and the division of nanoparticles are introduced there. In the practical part, the created program for the evaluation of fluorescence lifetime and spectral changes is described. The program can show two-dimensional lambda maps, the fluorescence lifetime and spectral shift in the space area. In the final part of the thesis, an experiment with rhodamine nanoparticles is carried out and it is evaluated using the created program and then discussed.
|
guest ::
