|
|
Study on the Supramolecular Structure of Humic Acids
Širůček, David ; Pekař, Miloslav (referee) ; Kalina, Michal (advisor)
This bachelor thesis is focused on the study of supramolecular structure of humic acids. This issue was studied on a number of HA samples which differed in source matrix (lignite, leonardite, soil, peat and compost). For these purposes, methods of size exclusion chromatography, dynamic and electrophoretic light scattering and UV-VIS spektrometry were used. In order to better understand the formation of the supramolecular structure of HA, the ways of its stabilization and how it was influenced by the change in pH, individual HA samples were studied in three pH-varying mediums (3,5; 7 and 12). The results obtained on a wide range of used humic acids are in accordance with the supramolecular theory of the structure of humic acids in aqueous solutions which describes them as freely-bound supramolecular associates of relatively small molecules having both polar and nonpolar parts and can be formed into more complex supramolecular aggregates depending on the conditions in the solution (pH, content of low molecular weight ions, etc.).
|
|
|
Thermal degradation of hyaluronan
Šimáčková, Marcela ; David, Jan (referee) ; Chytil, Martin (advisor)
This diploma thesis investigated thermal stability and the degradation of hyaluronan (HA) in HA with a molecular mass of 90–130 kDa and in HA with a molecular mass of 1 500–1 750 kDa. The following methods were used for the research: rheology, SEC-MALLS, TGA and DSC. Low-molecular HA was subject to time dependency of degradation investigation, where it was dried at a temperature of 90 °C for a period of 30 minutes and 60 minutes prior to the preparation of the solutions itself. High-molecular HA was investigated not only from the point of view of time but from the point of view of temperature dependency of degradation as well. In the case of investigating the time dependency of degradation, high-molecular HA was dried at a temperature of 75 °C at a time range from 15 minutes to 120 minutes prior to the preparation of the solutions. During the preparation of the solutions for discovering the temperature dependency of degradation, the high-molecular HA was then dried for a period of 30 minutes at a temperature range from 60 °C to 90 °C. For low-molecular HA, thermal stability was proven. Therefore, there is no decrease in the molecular mass and the solutions did not demonstrate a significant decrease of viscosity. For high-molecular HA, thermal stability was not proven. Degradation due to the temperature of drying as well as the time of drying occurred, which was demonstrated by a significant decrease in molecular mass and viscosity of the solutions. While in the case of using a drying temperature of 60 °C, a decrease in the molecular mass occurred by approximately 5 %, the molecular mass decreased by approximately 20 % at a drying temperature of 90 °C compared to undried HA. Due to this reason, high-molecular HA was also further investigated by means of the TGA method, where the decrease of humidity of HA samples in relation to the drying temperature was observed. The DSC method was also used. The objective of the DSC method was to find out temperatures, at which evaporation of humidity contained in an HA sample in relation to its form (undried HA, dried HA and lyophilized HA) occurs. This method further finds out the heat necessary to evaporate humidity from an HA sample. To conclude this research, the results obtained for high-molecular HA were compared with the results of other drying processes – lyophilized proved to be a very gentle drying method because a decrease in the molecular mass for lyophilized HA compared with undried HA almost did not occur.
|
|
|
Direct Synthesis of High-Molecular Polymers of Lactic Acid
Mikulík, David ; Kupka, Vojtěch (referee) ; Petrůj, Jaroslav (advisor)
This master thesis deals with the direct synthesis of polymers from lactic acid. The theoretical part focuses on both natural and synthetic ways of production the lactic acid monomer, their advantages and properties. Furthermore, the theoretical part focuses on the synthesis of poly(lactic acid) (PLA) from lactide, and direct polycondensation from lactic acid discussing about influences of catalysts, co-catalysts as well as chain extenders. The experimental part focuses on the synthesis of PLA polymers and co-polymers wherein investigates suitable catalysts, reaction medium for azeotropic dehydration and co-catalyst influence on products. Thermal and analytical analysis of PLA polymers are mentioned at the end of the experimental part.
|
|
|
Study of hyaluronan-albumin systems using light scattering methods and calorimetry
Sereda, Alena ; Hermannová, Martina (referee) ; Chytil, Martin (advisor)
This thesis, which is a continuation of the previous Bachelor thesis, is dedicated to the study of polyelectrolyte complexes between hyaluronan (HA) and bovine serum albumin (BSA). Interactions between HA and BSA and a formation of complexes were studied by SEC-MALLS method, where a molar mass, a root mean square (rms) radius, a hydronamic radius and an intrinsic viscosity of particles of the system were defined. Furthermore the interactions were studied by calorimetric measurement ITC, where thermodynamic character of complex formation was determined. Additionally, dynamic and electrophoretic light scattering methods (DLS and ELS) were applied, where hydrodynamic radius and a value of the zeta potential were defined. Also the effect of higher temperature on the character and complex formation was examined by SEC-MALLS and ITC measurements. The interactions were confirmed at any of the used media, but with different efficiency. It was also proved that complexes become smaller in their radii and viscosity with growing BSA concentration. Furthermore it was proved, that the high ionic strength hinders surface charges of HA and BSA molecules and minimizes their mutual interactions. At the higher ionic strength the radii of the complexes, their intrinsic viscosity and zeta potential are increased. The higher temperature has only minimal effect on the formation of the complexes.
|
|
|
Control the molecular weight of hyaluronic acid (HA) by adjusting the specific growth rate of culture Streptococcus equi subsp. zooepidemicus
Osičková, Jana ; Pepeliaev,, Stanislav (referee) ; Franke,, Lukáš (advisor)
This master thesis focuses on the effect of cultivation parameters on hyaluronic acid synthesis during its biotechnological production. The cultivation parameters were temperature of the cultivation, aeration, agitation, carbon source and addition of phosphatidylcholine. Changes in molecular weight and yield of hyaluronic acid, growth of biomass and medium viscosity were observed. From the obtained data we learned, that the specific growth rate greatly impacts final characteristics of hyaluronic acid. Under suboptimal temperatures a high molecular weight polymer was synthesised along with comparable yields from the control cultivation. High temperatures (40 °C) caused a dip in molecular weight. The next cultivation parameters were aeration and agitation. The highest molecular weights were obtained in cultivations with high agitation rates and intensive aeration, specifically 1 vvm/800 rpm and 2 vvm/800 rpm. Agitation had a bigger influence on molecular weight than aeration. When the carbon source was changed from sucrose to glucose, the lowest molecular weight and yield were obtained. Addition of phosphatidylcholine with concentration 160 mg/l had a positive effect on the cultivation, where the molecular weight grew and biomass growth was higher.
|
|
|
The effect of the molecular weight of poly(I:C) on the development and behavior of offspring in the maternal immune activation model
Cmarková, Nathalie ; Brožka, Hana (advisor) ; Petrásek, Tomáš (referee)
Maternal inflammation during pregnancy is associated with an increased risk of the development of psychiatric disorders in offspring, especially schizophrenia and autism. Prenatal treatment with poly(I:C), a viral mimetic, is a widely used model of maternal immune activation leading to developmental and behavioral alterations in offspring. However, results of studies are inconsistent possibly due to the differences in the molecular weight of used poly(I:C). In this thesis, the effect of different molecular weights of poly(I:C) was assessed. Pregnant Wistar rat females were treated by either high molecular weight (HMW) or low molecular weight (LMW) poly(I:C) on gestational day 14 to assess developmental and behavioral deficits relevant to schizophrenia and autism in offspring on postnatal day 12 and at three months. Prenatal exposition to the HMW poly(I:C) led to significantly reduced social behavior in the Homing test and a trend towards reduced USV vocalization in pups. The LMW pups showed significantly impaired negative geotaxis. In adulthood, the HMW and LMW offspring both exhibited significant social deficits and reduced anxiety. Anxiety was reduced mainly in the LMW group. This thesis revealed differences in behavioral outcomes between prenatal exposition to HMW and LMW poly(I:C). These...
|
|
|
Influence of molecular weight of polymers on phase-separated hydrogels
Kolomá, Nikola ; Smilek, Jiří (referee) ; Mravec, Filip (advisor)
This work is focused on study of individual systems of hyaluronan mixtures. All mixtures of hyaluronans they were ready at molecular weights of 15-30 kDa, 80-150 kDa, or 1500-1750 kDa. These individual molecular weights were combined in different ratios most often in ratios of 70:30, 50:50 and 30:70. Septonex surfactant was used for all mixed samples and CTAB was used for last experiment too. At first the gel samples were prepared by a dry route of individual powders with accurately calculated batches. All solutions were prepared wet route with stock of exactly calculated concentration. Physical gels were prepared by combinations of Septonex and hyaluronan with the different molecular weights. In solution formed irregular shapes which we could describe as "marbles" or "beads". After the sample was to stand, the individual „marbles“ of the gel were formed whole mass. Was done too many experiments with physical gels, which has been carried out behavior of mixtures hyaluronans with different molecular weights. All physical and chemical properties were observed by the eye, described and in the and were photographed. Was used hydrophil dye in experiments and served for better visualize comparison samples between themselves. The last experiment was rheological measurement with which is possible characterize viscosity od individual samples.
|
|
|
Study of the adheisve affinity into the wood cell wall at the sub-microstructural level
Mitrenga, Ondřej ; Rovnaník, Pavel (referee) ; Vaněrek, Jan (advisor)
This thesis focuses on the problematic of adhesive affinity into wood cell wall at the sub-microstructural level. The main subject of this thesis is research work of scholarly articles focused on the penetration of resins and polymers into the cell wall of the wood. In contains a description of the principles on which the used methods are based, and a summary of the results achieved. In the experiment, several method were used to investigate the possible penetration of selected methods adhesives into the structure of the cell wall. These are fluorescence microscopy, confocal microscopy, scannin electron microscopy (SEM) and transmission electron microscopy (TEM).
|
|
|
Study of adhesive penetration into the wood cell wall
Janová, Petra ; Krbila, Jaromír (referee) ; Vaněrek, Jan (advisor)
This labor is based on penetration of adhesive into a wood cell walls. It focuse on adhesives basicly used for construction purposes, especially on epoxy resins. The labor contains the use of methods for precise detection adhesive in wood and methodics for choice of adhesive and wood basically used for bonding. It describes the experimentally detected dependence of contact angle on viscosity epoxy resins.
|
|
| |
guest ::
