National Repository of Grey Literature 11,315 records found  1 - 10nextend  jump to record: Search took 0.31 seconds. 


Plasma spraying from liquids: plasma liquid interaction and coating build up
Tesař, Tomáš ; Mušálek, Radek ; Medřický, Jan ; Lukáč, František
Plasma spraying from liquid feedstocks is a rapidly developing field of thermal spraying since the coatings prepared from liquids exhibit some unique features, such as high hardness, thermal shock resistance or low thermal and electric conductivity. The key factor influencing the final coating character and properties is the input material which may be in the form of a suspension or a solution. Parameters of the selected suspension (solids concentration, viscosity, surface tension, chemical composition, etc.) or solution (concentration, etc.) determine its interaction with the plasma jet which strongly influences the coating buildup. This proceeding introduces the problematics of the interaction between the liquid feedstock material with the plasma jet and presents the way of evaluation of the coating buildup.

Noise, Transport and Structural Properties of High Energy Radiation Detectors Based on CdTe
Šik, Ondřej ; Lazar, Josef (referee) ; Navrátil, Vladislav (referee) ; Grmela, Lubomír (advisor)
Poptávka ze strany vesmírného výzkumu, zdravotnictví a bezpečnostního průmyslu způsobila v posledních letech zvýšený zájem o vývoj materiálů pro detekci a zobrazování vysokoenergetického záření. CdTe a jeho slitina CdZnTe. jsou polovodiče umožnují detekci záření o energiích v rozsahu 10 keV až 500 keV. Šířka zakázaného pásma u CdTe / CdZnTe je 1.46 -1.6 eV, což umožňuje produkci krystalů o vysoké rezistivitě (10^10-10^11 cm), která je dostačující pro použití CdTe / CdZnTe při pokojové teplotě. V mé práci byly zkoumány detektory CdTe/CdZnTe v různých stádiích jejich poruchovosti. Byly použity velmi kvalitní spektroskopické detektory, materiál s nižší rezistivitou a výraznou polarizací, detektory s asymetrií elektrických parametrů kontaktů a teplotně degenerované vzorky. Z výsledků analýzy nízkofrekvenčního šumu je patrný obecný závěr, že zvýšená koncentrace defektů způsobí změnu povahy původně monotónního spektra typu 1/f na spektrum s výrazným vlivem generačně-rekombinačních procesů. Další výrazná vlastnost degenerovaných detektorů a detektorů nižší kvality je nárůst spektrální hustoty šumu typu 1/f se vzrůstajícím napájecím napětí se směrnicí výrazně vyšší než 2. Strukturální a chemické analýzy poukázaly, že teplotní generace detektorů způsobuje difuzi kovu použitého při kontaktování a stopových prvků hlouběji do objemu krystalu. Část mé práce je věnována modifikaci povrchu svazkem argonových iontů a jejímu vlivu na chemické složení a morfologii povrchu.


Surface modification of glass fibers for polymer composites
Knob, Antonín ; Marek,, Aleš (referee) ; Burša, Jiří (referee) ; Čech, Vladimír (advisor)
The doctoral thesis is aimed at preparation of glass fiber reinforced polymer composites with controlled interphase formed by plasma-polymerized tetravinylsilane and tetravinylsilane/oxygen thin films. The thin polymer films of specific physico-chemical properties and thickness were deposited to improve interfacial adhesion of glass fiber/polyester composites. The fiber surface modification was performed by using plasma enhanced chemical vapor deposition in low-temperature RF plasma operating in an various effective power range and different treatment time. Test results were examined in relation to the interlayer thickness and different treatment conditions. The prepared interlayers were analyzed to evaluate physico-chemical composition and properties (XPS, RBS, ERDA, FTIR and spectroscopic elipsometry). Selected mechanical properties were evaluated by AFM. Mechanical response of plasma interlayers was evaluated by short beam shear test and direct method of testing the interfacial shear strength using microindentation. The interphase shear failure was controlled by the shear strength at the interlayer/fiber interface as follows from experimental and model data.

Korelační vyhodnocení geochemických a petrograficko-mineralogických vlastností dochovaných vzorků ložiska Címovec-jih s typovým profilem vrtu CS-1
Breiter, Karel
Zpráva popisuje petrografický, mineralogický a geochemický charakter archivních vzorků greisenů z oblasti ložiska Cínovec-jih. Bylo stanoveno chemické složení celkových horninových vzorků a detailně byly studovány všechny zastižené rudní minerály. Charakter rudních minerálů byl porovnán s daty z centrální části ložiska a z vrtu CS-1.

Comparison of HPLC a GC-MS method for pesticide determination in soil
Chalbia Václavíková, Alena ; Kočárek, Martin (advisor) ; Havlík, Jaroslav (referee)
Physical and chemical properties of pesticides may vary significantly. Pesticides can be acidic, neutral or alkaline. Some compounds containing phosphorus, other sulfur, nitrogen or halogens. These atoms can be important for the detection of pesticides. Some of the compounds are volatile, others on the contrary not evaporate, which is also one of the important properties for chromatography. The diversity of pesticides actually makes it impossible to create a universal method, which is very impractical in terms of quality and time determination. Because that pesticides are one of the most chemicals in most countries. In the food and drinking water are limits on pesticides in order to avoid negative impact on public health. For residues in soil or surface water limits are set. (Lutz et al., 2006) The objective of this thesis is to evaluate the possibility of using two types of chromatographs with different detectors for the analysis of pesticide. Pendimethalin which was chosen for this work, will be analyzed usinga liquid chromatograph with UV detektor and gas chromatography with mass detector. Both this method will be compared as well two extraction methods (Soxhlet extraction and shaking), and two extraction agents (methanol and acetonitrile). Another point of the work is to provethe hypothesis that, for the determination of pendimethalin in soil is by gas chromatography using a mass spectrometer in comparison with the high performance liquid chromatography time and more expensive, but will achieve a higher yield and a lower detection limit of the pesticide.

The use of (nano)oxides for metal and metalloid stabilization in contaminated soils
Michálková, Zuzana ; Komárek, Michael (advisor) ; Luke, Luke (referee)
The main objective of the thesis was to evaluate the potential of selected Mn and Fe (nano)oxides for the stabilization of metals and metalloids in contaminated soils. The research was focused basically on three materials - commercial nanomaghemite (Fe III), nanomagnetite (Fe II,III) and a synthetic amorphous Mn oxide (AMO). The main aim of the work was to provide a complex view on the chosen stabilizing amendments regarding not just their direct influence on contaminants mobility and stabilization mechanisms, but also their stability and alterations in soil conditions together with influence on soil microorganisms and higher plants. Firstly, adsorption properties of the tested materials towards Cd, Cu, Pb and As were investigated. In this context, the most effective material showed to be the AMO reaching one to two orders of magnitude higher adsorption capacities than Fe III and Fe II,III under given experimental conditions. Interestingly, the rate of As(V) adsorption onto AMO was increasing with increasing pH as a result of high pHzpc of the AMO (8.1) and significant dissolution of this phase at lower pH values. As a next step, the influence of (nano)oxides on metal(loid)s mobility and other physico-chemical soil characteristics after application to contaminated soil was examined. Again, the AMO proved to be the most efficient in reducing mobile pools of Cd, Cu, Pb, Zn and As. On the other hand, Fe III and Fe II,III addition had generally less significant effects on contaminants mobility. AMO application further resulted in an increase of soil pH connected with AMO dissolution and unwanted decomposition of soil organic matter. When (nano)oxides alterations in soil conditions were observed, MnCO3 coatings were identified on AMO surface while no significant changes were recorded for Fe III and Fe II,III. As the MnCO3 formation was connected with increased AMO stability, AMO particles synthetically covered with MnCO3 coating (denoted as SM AMO) were prepared. Although the SM-AMO had a lower mass loss in soil than pure AMO, the stabilizing efficiency was almost the same for both materials. The differences in surface composition of both materials were decreasing with time as MnCO3 naturally precipitated on the AMO surface in soils while the SM AMO coating was gradually dissolving. When investigating the effect on soil microbiota, AMO efficiently promoted soil microbial activity while no significant changes were observed in the case of Fe III and Fe II,III. The AMO was also able to reduce the uptake of Cd, Pb and Zn by sunflower (Helianthus annuus L.), eliminate Zn phytotoxicity symptoms and increase biomass yield. On the other hand, toxic levels of Mn released from the AMO in an acidic soil were found in sunflower tissues. AMO application is thus recommended for contaminated neutral or slightly alkaline pH with a higher cation exchange capacity in order to avoid unwanted release of Mn. Finally, various types of AMO-biochar composite sorbents were recently prepared and field experiment focused on stabilization of Cd, Pb, Zn and As using studied materials is currently under preparation. The combined results from the thesis highlight the importance of a complex experimental approach dealing with all parts of the contaminated soil environment in order to obtain complete information about the efficiency and usefulness of any newly developed stabilizing amendment.

The influence of time in feed enrichment with unsaturated fatty acids to selected parameters of pig carcass value with regard to the fatty acid composition of intramuscular fat
Pantoflíček, Jiří ; Čítek, Jaroslav (advisor) ; Miloslav, Miloslav (referee)
The thesis aims to evaluate the impact of aliment with higher contents of unsaturated fatty acids, consumed for a different period of time, to utilitarian attributes of pigs before a slaughter, with respect to the composition of fatty acids in the intramuscular fat of tested animals. The factors that influence the quality of meat are interior, exterior and technological. Among the qualitative markers of quality of meat we rank the share of meat and fat, acidification rate, color, viscosity, contents of intramuscular fat (marbling), smell, taste, juiciness and delicacy. Together with hygienic and nutritive attributes, consumers and processors consider these technological and sensory aspects to be the most important. The ultimate goal of this thesis is to compare the impact of different length of feeding soy oil on parameters of pork meat quality and growth. However, the interference of growth attributes was inconclusive and the test result came similar in different groups of tested pigs. What was influenced by adding the soy oil into the feed is the fatty acids profile. The contents of fatty acids remained unchanged in every test group. Over time the content of monounsaturated fatty acids decreased. The most significant change occurred in representation of polyunsaturated fatty acids, which increased in the test groups with longer period of feeding with enriched feed, mostly at the expense of monounsaturated fatty acids. The differences between the test groups of pigs were statistically inconclusive; therefore the soy oil enrichment did not worsen the technological parameters of meat and fat quality. The longer period of feeding the soy oil enriched feed led to significant increase in polyunsaturated fatty acids. According to the findings, adding the soy oil into the feed will have no effect at all if done short time before the slaughter.

Analysis of biological features of Capsella bursa-pastoris (L.) Med.
Schneebergerová, Tereza ; Hamouz, Pavel (advisor) ; Holec, Josef (referee)
The aim of this bachelor thesis is to determinate selected biological characteristics of shepherd´s-purse, which have impact on the establishment and expansion of its populations in field crops. In particular, development of primary dormancy was studied and the effect of factors that influence the dormancy and germination of seeds was determined. Shepard´s purse is an annual or biennial herb of the cabbage family, which is classified as winter annual weeds. Primarily infest the winter and spring crops, rapeseeds, potatoes or forages. It appears from lowland to foothills, so biological features of individual population can be very different. The ways of control are shallow tillage or herbicidal treatment. After harvesting of ripe seed the first experiment was set to define the primary dormancy. Remaining seeds were stored in two different types of environment. Part of seeds was stored in the dry at 20 °C. Others seeds were stratified at 5 °C. Effect of storage conditions on primary dormancy was tested every two weeks. Seeds were germinated for 1 week in grow chamber under the influence of various factors such as different light mode, type of water and type of media for germination. The results were processed by multiple-factor analysis of variance. Fresh seeds showed a strong primary dormancy at constant temperatures of 10 °C and 20 °C. Treatment with fluctuating temperature (20/10 °C), filter paper, drinking water and stored in dark had the highest germination rate (10.75 %). Seeds stratified at 5 °C had increase in germination in first weeks, but lost it during storage. On the other hand, seeds stored in dry at 20 °C firstly were in dormancy, but they lost it gradually during storage.