|
|
Microbending fiber optic sensors
Švestka, Jiří ; Štohl, Radek (referee) ; Šedivá, Soňa (advisor)
This thesis deals with the influence microbending the transmitted signal at the bare optical fiber. Microbending influence on the transmitted signal is investigated in this work by changing the weight, power and water level in the tank by using this test fixture. The results of the experiments are proposed to enter the laboratory tasks to measure the impact microbending the transmitted signal in the subject line fiber-optic sensors (MOES).
|
|
|
Parameters of FTTx networks - Quality of services
Winkler, Aleš ; Reichert, Pavel (referee) ; Münster, Petr (advisor)
The main subject of this diploma thesis is to make a proposal to improve the optical access network for the transmission of Triple play services. I would here to the reader clarify method of proposal of optical network. There are described the kinds of optical access networks with parameters, for which we must look by their construction. There are described the modern methods of construction optical network too. In the theoretical part are discussed used architecture of networks too. I met here known standards, which I compared for big importance by their choice. A reason of construction of optical network are services known like Triple play. These services together with their problems and parameters are here discussed too. At the end of theoretical part I listed here measuring method for getting negative attribute distorting the led signal. In practical part the locality witch use the optical signal as the source of information is ordered. These network use unfit connections and has less possibilities than usual and this is the reason, why is the network not able to supply Triple play in requested quality. At first the analysis of ordered network was needed. Situation was complicated by the fact, that it has been prohibited entrance to me. The structure of network and network parts was known and documented by me. I made the proposals to improve this network in practical part. By the first proposal remained original kind of access network FTTB, but used new parts with higher performance. By the second proposal I made the network FTTH, by which it was possible to use the last haul optical cables with treatment and using new elements. It was needed to create solution by flat units. The resulting proposals are here evaluated, compared and cost evaluated. For rejection of access to optical network I did not make measuring, so I made simulation for variant FTTH for getting some parameters negative acting transmission.
|
|
|
Parameters of FTTx networks - Quality of services
Winkler, Aleš ; Reichert, Pavel (referee) ; Münster, Petr (advisor)
The main subject of this diploma thesis is to make a proposal to improve the optical access network for the transmission of Triple play services. I would here to the reader clarify method of proposal of optical network. There are described the kinds of optical access networks with parameters, for which we must look by their construction. There are described the modern methods of construction optical network too. In the theoretical part are discussed used architecture of networks too. I met here known standards, which I compared for big importance by their choice. A reason of construction of optical network are services known like Triple play. These services together with their problems and parameters are here discussed too. At the end of theoretical part I listed here measuring method for getting negative attribute distorting the led signal. In practical part the locality witch use the optical signal as the source of information is ordered. These network use unfit connections and has less possibilities than usual and this is the reason, why is the network not able to supply Triple play in requested quality. At first the analysis of ordered network was needed. Situation was complicated by the fact, that it has been prohibited entrance to me. The structure of network and network parts was known and documented by me. I made the proposals to improve this network in practical part. By the first proposal remained original kind of access network FTTB, but used new parts with higher performance. By the second proposal I made the network FTTH, by which it was possible to use the last haul optical cables with treatment and using new elements. It was needed to create solution by flat units. The resulting proposals are here evaluated, compared and cost evaluated. For rejection of access to optical network I did not make measuring, so I made simulation for variant FTTH for getting some parameters negative acting transmission.
|
|
| |
|
|
Methodology for the measurement of optical arterial network
Chleboun, Jan ; Dostál, Otto (referee) ; Filka, Miloslav (advisor)
There are methods to extend the transmission channel of optical transmission medium thanks to the development of telecommunications and informatics. Multiplex is a grouping of signals into a single transmission path and wave-division multiplexing is the best reason of use of the maximum fiber optic transmission capacity. The subject of this work is to determine whether a particular transmission path is suitable for such an extension of their capacity and how much. The answer is obtained by measuring the attenuation, the chromatic dispersion and the polarization mode dispersion, whose values are strictly limited and which determine next steps in the expansion of the transmission path, which is comprised by optical medium. Measurement methods determine the nature of the measured route and its current transmission capacities. Draft of the measurement methodology, which ensures the correct procedures during a possible transition to higher speeds is the output of this work. Thanks to the acquired characteristics of the BAPS (the Brno Academic Computer Network), the bit rate 40 Gb/s can be provided on this part of the network under the conditions of the introduction of certain countermeasures, particularly the exchange of a connectors on the measured optical lines. As for the back reflection lines in excess of the standard recommendation and pre-emptively on the lines with values with still agree with the return loss. Countermeasure for limiting of the chromatic and the polarization mode dispersion are do not need to stand in the way of a planned transition to a higher rate of the BAPS.
|
|
|
Transmission parameters of optical access networks
Ježek, Jaroslav ; Kapoun, Vladimír (referee) ; Havelka, Dušan (advisor)
The essence of this thesis is the cognition of theoretical basis for measuring on optical fibres, elements and optical wireway as well. This work describes the methods of measuring and detection of parameters of these networks. The gained knowledge is followed by its application on two laboratory tasks. The first task is focused on usage of method of embedded loss for measuring of attenuation of fibre and followed by usage of the method OTDR for localization of defect. The second task is focused on measuring of attenuation on passive optical element using only the method of embedded losses. The laboratory tasks were described and respective conclusion and findings were drawed from each other.
|
|
|
Free-Space Optics data link
Šála, Jakub ; Číž, Radim (referee) ; Šporik, Jan (advisor)
In this thesis, shows a current issue for free space optics, limiting their use in practice with regard to the availability and reliability. They conducted measurements on wireless optical links and the observed values is calculated by the availability of the connection. Subsequently, measurements are performed on alternate versions of wireless and copper connections. Observed values were compared with a wireless optical link. It is made of optical design of wireless connections at home.
|
|
|
Computer design of a digital radio link
Havel, Ladislav ; Nováček, Zdeněk (referee) ; Láčík, Jaroslav (advisor)
The Terrestrial digital radio links are used for transmitting digital information between fixed stations on a line of sight of a radio path. Each digital radio link has many characteristics and parameters for transmission. We require technical parameters in the design of digital radio link such as data rates and capacities. In this design we should take into account most effects of the electromagnetic waves propagation, if we want to meet user technical requirements of the link and if that link may correctly transmit digital signals with minimum errors. Prediction methods for the design of terrestrial line of sight systems are still in progress. Some effects of electromagnetic waves propagation and methods of the digital radio link design depend on natural variability and climate. The goal of this diploma thesis is to investigate methods for the design of terrestrial line of sight links with taking into account of ITU recommendation. Make computer program which implement this investigate methods
|
|
| |
|
|
Effect of optical connectors quality on transmission
Bernkopf, Miroslav ; Křepelka, Václav (referee) ; Filka, Miloslav (advisor)
This diploma thesis deals with optic fiber connectors and their influence on transmissions realized via fiber optics. Optical fibers and lightguides play the key role in telecommunications because of constant demands of higher bandwidth and data rates. Original metalic wires do not meet market requirements and so the fiber optics are more and more being used. There are various types of fibers and there are also many ways of connections. This work deals with demountable way of connection – optical connectors, which have the biggest influence on a total attenuation and route length. Connector has to meet various requirements such as cleannes, quality, mechanical construction and ferrule polishing.
|
guest ::
