Original title:
Některé otázky předcertifikačních testů EMC
Translated title:
Some Aspects of EMC Pre-Compliance Testing
Authors:
Vídenka, Rostislav ; Soldán, Josef (referee) ; Mazánek, Miloš (referee) ; Dřínovský, Jiří (advisor) Document type: Doctoral theses
Year:
2010
Language:
cze Publisher:
Vysoké učení technické v Brně. Fakulta elektrotechniky a komunikačních technologií Abstract:
[cze][eng]
Tato dizertační práce se zabývá předcertifikačními testy EMC se zaměřením na měření vyzářeného rušení. Práce shrnuje dosavadní poznatky omezování vlivu rušivého elektromagnetického pozadí a zaměřuje se na omezování vlivu nedokonalostí pracoviště a na výsledky měření vyzářeného rušení. Dále je popsán postup pro „kalibraci“ předcertifikačního měřicího pracoviště s využitím speciálních signálových zdrojů spolu s doporučeními, kterým bodům při „kalibraci“ je nutné věnovat pozornost. Jsou zde uvedeny výsledky porovnání měření v plně a v částečně bezodrazových komorách. Probrány jsou některé metody k potlačování vlivu rušivého elektromagnetického pozadí na výsledky měření vyzářeného rušení. Velká pozornost je pak věnována výběru a sestavení pracoviště na otevřeném prostředí a doporučením pro jeho minimální rozměry. V závěru práce je uveden doporučený postup pro předcertifikační měření vyzářeného rušení se zohledněním dostupného přístrojového vybavení.
This doctoral thesis deals with EMC pre-compliance testing of radiated disturbance. The thesis summarizes present pieces of knowledge about restricting of disturbing ambient signals and focuses on restricting of test site imperfection influence on the measurement results. Pre-compliance test site “calibration” uses comparison signal sources. There were added up the recommendations for “calibration” steps, too. The semi-anechoic vs. fully-anechoic chambers measurements results were compared. Some methods for dealing with ambient disturbing signals were discussed and high attention was applied to the test site choice and the minimal dimension geometry was recommended. There are presented recommendations for pre-compliance radiated disturbance measurements in the conclusion with the stress on available test equipment.
Keywords:
CNE; EMC; ERS; OATS; Pre-compliance testing; radiated disturbance measurement; CNE; EMC; ERS; měření vyzářeného rušení; OATS; Předcertifikační měření
Institution: Brno University of Technology
(web)
Document availability information: Fulltext is available in the Brno University of Technology Digital Library. Original record: http://hdl.handle.net/11012/13971