Název:
Výroba rohového dřezu
Překlad názvu:
Production of a corner sink
Autoři:
Soldán, Josef ; Dvořák, Milan (oponent) ; Císařová, Michaela (vedoucí práce) Typ dokumentu: Diplomové práce
Rok:
2019
Jazyk:
cze
Nakladatel: Vysoké učení technické v Brně. Fakulta strojního inženýrství
Abstrakt: [cze][eng]
Práce je zaměřena na výrobu rohového dřezu z plechu z nerezové oceli 1.4301. Na základě analýzy možných řešení výroby byla v souladu se zadáním práce zvolena výroba v několika tažných operacích pomocí konvenčního nástroje, čemuž se následně věnovala i teoretická část této práce. V praktické části byla provedena kontrola technologičnosti, následovaná návrhem vhodného tvaru polotovaru, stanovením počtu tahů v jednotlivých tažných operacích, výpočtem sil a prací a výpočtem parametrů tažidla. Tyto výpočty byly následně ověřeny za použití numerické simulace, která odhalila nedostatky, načež byla vhodně upravena geometrie zadané součásti, aby byly tyto nedostatky odstraněny. Na základě těchto výpočtů byl navržen tažný nástroj, který je koncipovaný jako univerzální. V závěru bylo provedeno technicko-ekonomické zhodnocení, které potvrdilo ekonomickou výhodu této univerzálnosti.
This diploma thesis if focused on the production of a corner sink from stainless steel sheet 1.4301. Based on analysis of manufacturing possibilities the best solution is to produce corner sink by a conventional tool in serval operations, which was the main focus of theoretical part of this thesis. In addition, this choose is in conform with assignment of this diploma thesis. Practical part of this thesis was focused on check of technologicity followed with design of suitable shape of sheet for deep drawing. Further calculation of amount of required draws in specific drawing operations, calculation of drawing forces and works and calculation of parameters of drawing tool. These calculations were checked by numerical simulation which discovered possible defects whereupon the shape of corner sink was modified in order to limit these defects. Based on these calculations the universal drawing tool was designed. In the ending of this thesis the techno-economic evaluation was made which confirmed the economic advantage of this universality.
Klíčová slova:
dřez; hluboké tažení; konvenční nástroj; MKP; ocel 1.4301; simulace; tvarově složitá součást; 1.4301 steel; complicated shape part; conventional tool; deep drawing; FEM; simulation; sink
Instituce: Vysoké učení technické v Brně
(web)
Informace o dostupnosti dokumentu:
Plný text je dostupný v Digitální knihovně VUT. Původní záznam: http://hdl.handle.net/11012/179142