Original title:
Analyse der thermischen Belastung des Werkstückes beim Trennschleifen von hochfesten Lagerlaufringen
Translated title:
Analysis of the thermal load of the workpiece during the cutting grinding of high-strength bearing rings
Authors:
Felgentreu, Sven ; Blecha, Petr (advisor) Document type: Master’s theses
Year:
2016 Publisher:
Vysoké učení technické v Brně. Fakulta strojního inženýrství Abstract:
[*][eng]
Práce se zabývá tepelným namáháním valivých ložisek s vysokou pevností, které jsou řezány pomocí brusného kotouče. Při lineárním způsobu řezání brousícím kotoučem značně vzrůstá teplota podél střižnice. Takto vzniklé teplo se hromadí v malém průřezu materiálu a dochází k tepelnému ovlivnění okolí místa řezu. Cíl této práce spočívá v navržení dvouosého řezání kotoučem za účelem snížit tepelné poškození materiálu. Nejdříve byl teoreticky posouzen současný postup řezání a na základě toho navržena dvouosá řezací strategie, která byla poté experimentálně ověřena. Použitím dvouosé strategie je možné dosáhnout významné redukce nárůstu teploty ve střižné ploše tak, že materiál není tepelně poškozen a současně nevzniká otřep. Nicméně, dvouosý způsob řezání vede ke zvýšení doby procesu, jenž je tedy nutné dále optimalizovat.
This work deals with the thermal load during cut-off grinding of high-strength bearing rings. Linear cut-off operations lead to a high rise in temperature over the cutting process. These leads, together with the limited material volume, in a heat build-up and the resulting grinding burn. The aim of this work was to prevent this head build-up by using two-axis cut-off operations. Therefore, known methods were theoretically considered and from this, alternative two-axis strategies were determined. For testing, experiments were carried out on a test set-up developed in this work. The tests showed that the two-axis strategies lead to significantly reduced temperatures, as well as non-grinding burn and partially burr-free cutting surfaces. However, the two-axis methods lead to increased process times, which is why approaches for their optimization have been discussed.
Keywords:
cut-off grinding; grinding burn; heat distribution; high-strengh steel; two-axis cut-off operations
Institution: Brno University of Technology
(web)
Document availability information: Fulltext is available in the Brno University of Technology Digital Library. Original record: http://hdl.handle.net/11012/63682