Název:
Výroba speciálních drážek v trubkách
Překlad názvu:
On the production of special grooves in pipes
Autoři:
Smítal, Tomáš ; Humár, Anton (oponent) ; Píška, Miroslav (vedoucí práce) Typ dokumentu: Diplomové práce
Rok:
2013
Jazyk:
cze
Nakladatel: Vysoké učení technické v Brně. Fakulta strojního inženýrství
Abstrakt: [cze][eng]
Tato práce byla vytvořena ve spolupráci s firmou Mubea. Úvodní část popisuje účel hlavové opěrky sedadel automobilů a funkci speciálních drážek, kterými je rám opěrky osazen. Následuje přehled technologií výroby těchto drážek se stručným výčtem jejich výhod a nevýhod. Hlavní část této práce spočívá v návrhu nové alternativní technologie výroby speciálních drážek do tenkostěnných trubek s následným experimentálním ověřením technologických podmínek a tvaru drážek. Práce obsahuje také vyhodnocení životnosti nástroje a jeho opotřebení. Interpretace dosažených výsledků je provedena početně a graficky.
This work was created in cooperation with company Mubea. Introduction part describes purpose of automotive headrest and function of special grooves, which are fitted on headrest frame. Overview of manufacturing technologies of these grooves with short summary of their advantages and disadvantages follows. The main part of this work consists of development of new alternative technology for manufacture special grooves in thin-walled tubes with following experimental verification of technological conditions and shape of grooves. This work also contains evaluation of tool life and wear. Interpretation of the results is performed by calculations and graphically.
Klíčová slova:
drážka; hlavová opěrka; tenkostěnná trubka; tváření; tření; forming; friction; groove; headrest; thin-walled tube
Instituce: Vysoké učení technické v Brně
(web)
Informace o dostupnosti dokumentu:
Plný text je dostupný v Digitální knihovně VUT. Původní záznam: http://hdl.handle.net/11012/27030