Original title:
Výroba víčka motoru pryží
Translated title:
Manufacturing of motor lid using rubber
Authors:
Brožek, Michal ; Šlais, Miroslav (referee) ; Podaný, Kamil (advisor) Document type: Bachelor's theses
Year:
2011
Language:
cze Publisher:
Vysoké učení technické v Brně. Fakulta strojního inženýrství Abstract:
[cze][eng]
Práce vypracovaná v rámci bakalářského studia předkládá návrh technologie výroby víčka motoru. Kryt bude vyráběn v sérii 300 ks/rok z plechu o tloušťce 1mm z materiálu ocel 17 240. Po provedení rozvahy možných způsobů výroby, byla zvolena technologie tažení nepevným nástrojem, polytanem. Literární studie je zaměřena na rozbor této technologie. Polotovar kruhového tvaru a průměru 222,3 mm bude vyráběn řezáním vodním paprskem z tabule plechu o rozměrech 1x1250x2500 mm. Využití tabule je 68,3%. K tváření součásti je použito hydraulického lisu Cth 250 od firmy ŽĎAS a.s. o jmenovité síle 2,5 MN, který má výrobní podnik k dispozici. Na základě konstrukčních výpočtů je navržen tažný nástroj pro metodu Guérin. Po provedení ekonomického zhodnocení byla stanovena cena výrobku na 115 Kč.
The work, developed in an undergraduate study, proposes technology of the motor lid. The case shall be produced in a series of 300 pieces per year of 1mm sheet steel 17 240. After an evaluation of possible modes of production, the technology of fragile drawing tool, polytan, was chosen. Literary study is focused on the analysis of this technology. The circular shaped semi-product about the diameter of 222.3 mm, will be produced by a water jet cutting of thin plates with dimensions 1x1250x2500 mm. The capacity utilization of the panel is 68,3 %. For the forming component part is a hydraulic press Cth 250 at a nominal power of 2,5 MN, which is available and made by the company ŽĎAS a.s., used. On the basis of design calculations is a drawing tool for method Guerin designed. After the economic evaluation, the product price was set at 115 CZK.
Keywords:
drawing; elastomer; surface forming; uncertain instrument; elastomer; nepevný nástroj; plošné tváření; tažení
Institution: Brno University of Technology
(web)
Document availability information: Fulltext is available in the Brno University of Technology Digital Library. Original record: http://hdl.handle.net/11012/799