Název: AGEING OF BINARY Ti-Ni ALLOY AND ITS INFLUENCE ON TRANSFORMATION CHARACTERISTICS
Autoři: Szurman, I. ; Kursa, M. ; Petlák, D. ; Dlouhý, Antonín
Typ dokumentu: Příspěvky z konference
Konference/Akce: METAL 2011 - Anniversary International Conference on Metallurgy and Materials /20./, Brno (CZ), 20110518
Rok: 2011
Jazyk: eng
Abstrakt: Transformation temperatures of binary alloys from Ti-Ni system are highly sensitive to chemical composition of the alloy. This sensitivity, however, causes rather considerable complications already during process of preparation. Transformation temperatures of bays rich in Ni can be successfully modified. The key to modification of transformation temperatures lies in use of precipitation reaction of quenched over-saturated solution for influencing of composition of TiNi matrix and thus to precise control of transformation temperatures. Principle of this method consists in metastable balance between intermetallic phase TiNi and coherent precipitates Ti3Ni4. Although the precipitate Ti3Ni4 is considered to be metastable in comparison with TiNi3, it is highly stable at temperatures below 600 degrees C. During precipitation reaction Ti3Ni4 is formed and this phenomenon is connected with decrease of Ni content in TiNi matrix, which leads to increased temperatures of phase transformations TR (temperature of formation of R-phase) and Ms (temperature 'martensite start'). It is important that transformation temperature after long-term ageing is independent on chemical composition of the alloy, and it depends only on temperature of ageing as a consequence of equilibrium between these phases. This phenomenon should not occur at ageing at higher temperatures, formation of precipitate Ti3Ni4 should occur only during cooling of the sample from the temperature of ageing. The alloy Ni50.6-Ti (at. %), prepared in high-frequency induction vacuum furnace, was chosen as experimental material. Samples of the alloy were sealed into evacuated quartz glass tube and aged at constant temperature with various durations of dwell. Afterwards transformation characteristics of the samples were determined by DSC method.
Klíčová slova: ageing; DSC measurement; martensitic transformation
Číslo projektu: CEZ:AV0Z20410507 (CEP)
Zdrojový dokument: METAL 2011: 20TH ANNIVERSARY INTERNATIONAL CONFERENCE ON METALLURGY AND MATERIALS, ISBN 978-80-87294-24-6

Instituce: Ústav fyziky materiálů AV ČR (web)
Informace o dostupnosti dokumentu: Dokument je dostupný v příslušném ústavu Akademie věd ČR.
Původní záznam: http://hdl.handle.net/11104/0279750

Trvalý odkaz NUŠL: http://www.nusl.cz/ntk/nusl-371438


Záznam je zařazen do těchto sbírek:
Věda a výzkum > AV ČR > Ústav fyziky materiálů
Konferenční materiály > Příspěvky z konference