National Repository of Grey Literature 237 records found  beginprevious228 - 237  jump to record: Search took 0.01 seconds. 
Cutting operation holes in change gear box to installation bearing (material basic: iron casting).
Bílek, Josef ; Prokop, Jaroslav (referee) ; Kalivoda, Milan (advisor)
This Bachelor work describes an issue of shaping the gaps for bearings´ fitting in casts of gear-boxes.The work itself is divided in two parts. In the first part the shaping by means of revolving desk is analised. In the second part the shaping without revolving desk is analised, which means shaping with fixed desk. The methods of quality measuring of shaped surfaces are also evaluated in this work too.
Wind power station tower - calculation
Stein, Pavel ; Vrbka, Martin (referee) ; Nevrlý, Josef (advisor)
The target of this labour is to give summary of contemporary level of construction of wind power station tower. The first part describes importance and progress of alternative sources of energy, especially wind energetic in Czech republic. Next point concerns some construct options of wind power station tower and its basic elements. Close of the work is oriented to modern forms in problems of the wind power station tower and indicates options of modern development.
The utilization of the individual gears for tractors higher power series
DRAHOŠ, Pavel
The aim of the bachelor thesis was to monitor the operation of two tractors with different transmission variants with a shift under full load and the group lifting under load, in terms of used gear at different working deployment (stubble, plowing, sowing). First, the literature review describes the historical development, construction and activity currently used tractor transmissions. The following is a description of the methodology of measurement and evaluation, bringing used calculation formula. Custom measurements were performed on tractors John Deere 7810 with transmission Powershift 19/7 and AutoQuad 20/20 and proved that in practise there are only using a few of the many gears installed. For a simple design optimization gears are used total tables extended with graphs for individual transmissions. Based on the measurement and after the data analysis is presented the proposal of transmission with 10 forward gears and 2 reverse gears with a fully stamped gears under load. Current manufactures and the market, however, now offer tractors with mechanical transmissions increasing amount of gears than in the past. Increasingly, the trend is promoting the installation of transmisson with the fluent change of transmission ratio to the current use of advanced contemporary electronic transmission control and engine tractor.

National Repository of Grey Literature : 237 records found   beginprevious228 - 237  jump to record:
Interested in being notified about new results for this query?
Subscribe to the RSS feed.