Original title:
Vliv popouštění na vlastnosti borové oceli
Translated title:
The influence of tempering process for properties of boron steel
Authors:
Doležal, Luděk ; Kubíček, Jaroslav (referee) ; Slováček, Marek (advisor) Document type: Bachelor's theses
Year:
2024
Language:
cze Publisher:
Vysoké učení technické v Brně. Fakulta strojního inženýrství Abstract:
[cze][eng]
Bakalářská práce se zabývá problematikou výskytu zbytkového austenitu u příčníku článku harvestorového kolopásu při popouštění po delší době. Zvoleným materiálem je borová ocel 27MnCrB5-2. Experiment probíhá porovnáním tří vzorků, první je popuštěn ihned po kalení, druhý 48 hodin po kalení a třetí popuštěn není. Dle předběžných výpočtů rychlostí ochlazování a teploty Mf je přítomnost zbytkového austenitu nepravděpodobná. U všech metalografických výbrusů je optickým mikroskopem pozorovatelná identická martenziticko-bainitická struktura. Na rastrovacím mikroskopu se u obou popuštěných materiálů vyskytuje dolní bainit s karbidy uvnitř feritických lamel. Pouze zakalený vzorek má obtížně rozlišitelné karbidy od martenzitické struktury, avšak bez známek zbytkového austenitu. Z výsledků měření tvrdosti má nejvyšší tvrdost zakalený příčník, a dle příslušné křivky v ARA diagramu odpovídá tvrdost bainitické struktuře. Výskyt zbytkového austenitu byl definitivně vyloučen rentgenovou difrakcí při nižším výskytu, než je 2% rozlišitelnost využitého zařízení.
This bachelor thesis deals with the problem of the occurrence of residual austenite in the crossbar of a harvester forestry tracks during tempering after a longer period of time. The chosen material is boron steel 27MnCrB5-2. The experiment is carried out by comparing three samples, the first is tempered immediately after quenching, the second is tempered 48 hours after quenching and the third is not tempered. According to preliminary calculations of cooling rates and Mf temperature, the presence of residual austenite is unlikely. On all metallographic smears, an identical martensitic-bainitic structure can be observed by optical microscopy. On a scanning microscope, both tempered materials show lower bainite with carbides within the ferritic lamellae. Only the quenched sample has carbides that are difficult to distinguish from the martensitic structure, but no evidence of residual austenite. Based on the hardness measurements, the quenched crossbar has the highest hardness. According to the corresponding curve in the CCT diagram, the hardness corresponds to the bainitic structure. The occurrence of residual austenite was definitely ruled out by X-ray diffraction at less than 2% resolution of the equipment used
Keywords:
27MnCrB5-2; boron steel; quench; residual austenite; tempering; 27MnCrB5-2; borová ocel; kalení; popouštění; zbytkový austenit
Institution: Brno University of Technology
(web)
Document availability information: Fulltext is available in the Brno University of Technology Digital Library. Original record: https://hdl.handle.net/11012/248041