Original title:
Ověření rychlosti vytvrzování a budování adheze PU lepidel v závislosti na vnějších podmínkách
Translated title:
Verification of setting speed and building adhesion of PU adhesives depending on external conditions
Authors:
Slatinská, Jana ; Žák, Ladislav (referee) ; Kubíček, Jaroslav (advisor) Document type: Master’s theses
Year:
2022
Language:
cze Publisher:
Vysoké učení technické v Brně. Fakulta strojního inženýrství Abstract:
[cze][eng]
Firma IFE a. s. (Knorr – Bremse) v Modřicích potřebovala ověřit proces vytvrzování lepených spojů u používaného lepidla Sikaflex®-265. Cílem bylo zjistit, zda je k vytvrzování nutno řízené prostředí, a hlavně zjistit vliv daných faktorů na rychlost vytvrzování a rychlost budování adheze ve spoji. Hlavními faktory, které byly zkoumány byla teplota, vlhkost, poměr Sikaboosteru® P-50 vůči testovanému lepidlu a čas vytvrzování. Z výsledku pak vyplývá, které faktory mají vliv a které pouze minimální. Cílem dále bylo ověření pevnosti spoje, kterou udává výrobce po konkrétním čase. Vliv na otevřený technologický čas nebyl měřen.
The company IFE a. S. (Knorr - Bremse) in Modřice needed to verify the curing process of glued joints with the used adhesive Sikaflex®-265. The aim was to find out whether a controlled environment is needed for curing and mainly find out influence of factors on the curing process and the velocity of building adhesion. The main factors that were investigated were temperature, humidity, the ratio of the Sikabooster® P-50 to the tested adhesive and the curing time. The result then shows which factors have an influence and which only minimal. The aim was also to verify the strength of the joint, which is stated by the manufacturer after a specific time. The impact on open technology time has not been measured.
Keywords:
adhesive joining technology; booster; climatic chamber; humidity; joint strength; peel test; polyurethane; shear test; temperature; booster; jednokomponentní polyuretan; klimatická komora; odlupová zkouška; pevnost spoje; smyková zkouška; technologie lepení; teplota; vlhkost
Institution: Brno University of Technology
(web)
Document availability information: Fulltext is available in the Brno University of Technology Digital Library. Original record: http://hdl.handle.net/11012/206179