Original title:
Analýza defektů měděné slitiny po elektroerozivním drátovém řezání
Translated title:
Analysis of defects of copper alloy after wire electrical discharge machining
Authors:
Vontor, Jakub ; Osička, Karel (referee) ; Mouralová, Kateřina (advisor) Document type: Master’s theses
Year:
2020
Language:
cze Publisher:
Vysoké učení technické v Brně. Fakulta strojního inženýrství Abstract:
[cze][eng]
Elektroerozivní drátové řezání, které reprezentuje nekonvenční technologie obrábění, je již na velmi vysoké technologické úrovni. Nicméně vlivem tohoto druhu obrábění vznikají v materiálu mnohé defekty a mění se kvalita obrobeného povrchu v závislosti na nastavených obráběcích parametrech stroje. S cílem optimalizace těchto parametrů v závislosti na výsledné kvalitě povrchu a vhodné řezné rychlosti byla vytvořena komplexní studie, která optimalizuje obráběním měděné slitiny Ampcoloy 35. Studie obsahovala experiment s 33 vzorky, každý z těchto vzorků byl obráběný s jiným nastavením parametrů a výsledky obrábění byly analyzovány.
Electrical discharge wire machining, which represents non-conventional machining technology is up on very high technological level. However, due to this type of machining many of defects are set on the material and the quality of machined surface is changed according to set parameters of machine. Complex study was created with the aim of optimization these parameters according to final quality of surface and right wire speed. This study include experiment with 33 samples, every of these samples was machined with different parameters, results of these machining were analyzed.
Keywords:
Ampcoloy; electrical discharge machining; non-conventional machining; WEDM; Ampcoloy; elektroerozivní obrábění; nekonvenční obrábění; WEDM
Institution: Brno University of Technology
(web)
Document availability information: Fulltext is available in the Brno University of Technology Digital Library. Original record: http://hdl.handle.net/11012/192300