Original title:
Konstrukce optického mikrotribometru
Translated title:
Design of optical microtribometer
Authors:
Poláček, Tomáš ; Zapletal, Tomáš (referee) ; Šperka, Petr (advisor) Document type: Bachelor's theses
Year:
2019
Language:
cze Publisher:
Vysoké učení technické v Brně. Fakulta strojního inženýrství Abstract:
[cze][eng]
Úkolem práce je návrh konstrukce optického mikrotribometru s možností dynamického měření kapalinového tření v simulovaném bodovém kontaktu. Přístroj má být navržen tak, aby umožňoval vhled mikroskopem v místě dotyku. V práci je popsána konstrukce vybraných přístrojů zkoumajících síly v kontaktech. Poukázáno je na jejich přednosti i nedostatky při použití v dané problematice. Parametry dotyku byly zjišťovány pomocí vzorců pro Hertzův tlak. Následně byl řešen návrh zátěžného členu, na němž má být uchycena kulička (jedna ze stykových ploch). S využitím tohoto členu a kapacitních snímačů polohy mají být následně měřeny síly a dynamické chování v kontaktu. K vyvození potřebného zatížení je použito mikrometrické hlavice a navrženého šestikloubového mechanismu. Potřebný pohyb v kontaktu je vytvořen rotací disku, kterou zajišťuje synchronní řemenový převod a synchronní motor. Na konci práce je zhodnoceno dynamické chování celého přístroje, přičemž jsou uvedeny frekvence, při nichž mohou být ovlivněny výsledky měření. Parametry navrženého mikrotribometru jsou porovnány s parametry zařízení popsaných v rešeršní části.
The aim of this work is to design an optical microtribometer with the possibility of dynamic measurement of liquid friction in simulated point contact. The device should be designed to allow a microscope to observe the point contact. The work describes the construction of selected devices investigating forces in contacts. Their advantages and disadvantages when used in the given problematics are pointed out. Touch parameters were determined using formulas of Hertz stress. Subsequently, the design of the cantilever on which the ball (one of the contact surfaces) is to be attached has been discussed. Using the cantilever and capacitive position sensors, forces and dynamic contact behavior are subsequently measured. The micrometer head and the designed six-joint mechanism are used to draw the necessary load. The required movement of contact is created by the rotation of the disk provided by the synchronous belt transmission and the synchronous engine. At the end of the work, the dynamic behavior of the device is evaluated, with the frequencies at which the measurement results can be influenced. The parameters of the proposed microtribometer are compared with the parameters of the devices described in the research section.
Keywords:
ball-on-disk tribometer; dynamic behavior; liquid friction; optical interferometry; point contact; ball-on-disk tribometr; bodový kontakt; dynamické chování; kapalinové tření; optická interferometrie
Institution: Brno University of Technology
(web)
Document availability information: Fulltext is available in the Brno University of Technology Digital Library. Original record: http://hdl.handle.net/11012/178871