Název:
Stanovení kinetiky drcení průmyslově vyráběných tablet
Překlad názvu:
Determination of the kinetics of crushing industrially produced tablets
Autoři:
Čechalová, Kateřina ; Řehula, Milan (vedoucí práce) ; Musilová, Marie (oponent) Typ dokumentu: Rigorózní práce
Rok:
2008
Jazyk:
cze
Abstrakt: [cze][eng] 7.SOUHRN V ČESKÉM A ANGLICKÉM JAZYCE 7.1. Souhrn Stanovení kinetiky drcení u průmyslově vyráběných tablet Cílem této rigorózní práce bylo určit optimální přístrojové parametry pro hodnocení pevnosti tablet. Byly testovány rychlosti předzatížení od 0,01 do 0,1 mm/s , předzatížení od 1 do 4 N a rychlosti cyklu od 5 do 20 N/s.Tyto parametry byly hodnoceny na základě záznamů síla - dráha.Z deformačních křivek byla vypočtena dráha drcení v mm ,drtící síla v N a energie drcení v N.mm. Zároveň byla hodnocena odčitatelnost křivek. Získané výsledky byly hodnoceny metodou analýzy průměrů podle Otta. Z výsledků vyplývá,že pro standardní stanovení mechanické odolnosti tablet je vhodné toto nastavení přístroje:Rychlost cyklu 0,01 N/s Předzatížení 4 N Rychlost předzatížení 5 mm/s7.2.Summary Determination of the Kinetics of Crushing of Mass-Produced Tablets The degree paper aimed to determine the optimal parameters of the devices for the evaluation of the strength of tablets. Rates of preloading from 0.01 to 0.1 mm/s, preloading from 1 to 4 N, and rates of the cycle from 5 to 20 N/s were tested. These parameters were evaluated on the basis of the records of the force-course. Deformation curves were employed to calculate the course of crushing in mm, crushing force in N, and energy of crushing in N.mm. The reading of the curves was evaluated as well. The obtained results were evaluated using the method of the analysis of diameters following Otto. The results show that for the standard determination of mechanic resistance of tablets, the following adjustment of the device is suitable: rate of the cycle, 0.01 N/s, preloading, 4 N, rate of preloading, 5.mm/s.