|
|
Analysis of hazardous metals in rPET granulate
Souček, Elena ; Řezáčová, Veronika (referee) ; Komendová, Renata (advisor)
Production of polymer products has increased rapidly in recent decades. Especially in food industry as a packaging it gained a dominant position when it replaced previously used materials. Due to the direct risk for human health it is necessary to be careful and pay attention to their composition. It is also necessary to develop methods to properly recycle and reuse already used material, not only produce new products. This thesis deals with the study of the content of risk elements in PET regranulate. The samples were completely decomposed by microwave radiation in an environment of concentrated sulfuric and nitric acid. They were subsequently analyzed by atomic absorption spectrometry (AAS). Flame atomization technique (FAAS) was used to determine Sb and Zn and electrothermal atomization (ETAAS) to determine Cd, Cr, Pb, Cu and Ni. This method was also used to study migration of antimony from samples to food simulant under different conditions (temperature, pH). This thesis follows up on the thesis of Mrs. Kryštofová who studied recycled PET flakes.
|
|
|
Study of the content of risk elements in power plant ash
Vlčková, Renáta ; Doležalová Weissmannová, Helena (referee) ; Komendová, Renata (advisor)
This thesis deals with the study of the content of the risk elements Hg, Cr, Pb and Cd in samples provided by the Thermal Power Plant. Samples of lignite, biomass, fly ash and bottom ash were collected monthly over a period of one year. In addition to this set of samples, river water and fly ash pond water were sampled monthly. A total of 72 samples were analysed by atomic absorption spectrometry (AMA 254 and ETAAS). The concentrations of the elements of concern in the lignite and biomass samples decrease in the order Cr > Pb > Hg > Cd and in the fly ash and bottom ash samples decrease in the order Cr > Pb > Cd > Hg. Overall, it was assessed that the concentrations of the risk elements after co-firing of lignite and biomass were mainly transferred to fly ash and less to bottom ash. It was found that the combustion of higher amounts of biomass decreased the Hg, Cr and Pb contents in both fly ash and bottom ash. The water samples according to the determined parameters were classified as unpolluted water.
|
|
|
Evaluation of ecotoxicity of selected chemicals with using algal test.
Kosárová, Hedvika ; Pavlovský, Jiří (referee) ; Doležalová Weissmannová, Helena (advisor)
This bachelor thesis deals with the ecotoxicity of 2 - [(2,6-dichlorophenyl)aniline] benzene acetic acid (diclofenac), ?-methyl-4-(2-methylpropyl) benzene acetic acid (ibuprofen) and mixture of cadmium and diclofenac and studies the above using algal toxicity test in accordance with ISO 8692. The theoretical part describes the issue of pharmaceuticals in the environment, and characteristics of standards algae tests and alternative tests. Freshwater green algae Desmodesmus subspicatus were used as testing organisms in all the implemented algal toxicity tests. By the means of these tests, the IrC50 values for the standard substance potassium dichromate, the drugs diclofenac and ibuprofen and cadmium were determined. The toxicity of cadmium in mixture with diclofenac was also evaluated.
|
|
|
The study of vertical mobility of heavy metals and their transfer to mushrooms
Jurnečka, Roman ; Doležalová Weissmannová, Helena (referee) ; Komendová, Renata (advisor)
This bachelor thesis deals with the issue of contamination of forest soils and edible mushrooms with lead, cadmium, copper and zinc in the Jeseníky Mountains, specifically in the Domašov and Vápenná forests. Sampling took place at 12 localities, divided into spruce and beech stands. Atomic absorption spectrometry AAS ContrAA 800D was chosen to determine the content of selected heavy metals. Based on the measured values of the concentrations of the studied metals and other soil properties, dependences were created to determine the vertical mobility of selected metals in the soil profile. Vertical mobility depends on the physico-chemical properties of the soil (pH, C and S content). The dependence of the content of selected heavy metals in the soil on the pH value of the soil was found. In the case of lead, the sorption capacity of the soil organic component was confirmed. The risk and above-limit content of Pb, Cd and Cu was found on the yellow-boletus mushroom. Cadmium shows the highest bioavailability. Lead was evaluated as the element with the lowest mobility.
|
|
|
Thick-film sensors for heavy metals detection
Gajdoš, Libor ; Majzlíková, Petra (referee) ; Prášek, Jan (advisor)
This project describes the possibilities of heavy metals detections in solutions using differential pulse voltammetry with tree-electrode electrochemical thick-film sensors. In the theoretical part, the thick-film technology is described as well as thick-film pastes’ types and compositions, followed by introduction to electrochemistry and electro-analytical methods of measurement. This project also describes the three measured heavy metals – cadmium, lead and copper. In the practical part, heavy metals’ ions detection in solutions using carbon working electrode and determination of the detection limit and sensitivity are described and discussed. Finally the evaluation of obtained results and results comparison to hygienic limits are included.
|
|
|
Study of CdTe sensor properties
Vašíček, Martin ; Holcman, Vladimír (referee) ; Grmela, Lubomír (advisor)
This Bachelor Thesis is focused on studies of CdTe detector characteristics. It is to describe the analysis of transport and noise characteristics of CdTe samples at different temperatures. Evaluation of our results proves that CdTe junction behaves like an antiseries connection of a pair of diodes. The courses of VA characteristics are noted for linear or slightly exponential growth. When temperature is growing , conductivity of the samples is growing too. Our measurements demonstrated difference in conductivity of samples tested at the same temperature. It is also obvious that within very low range of frequencies the factor of noise 1/f is dominating. From 10Hz frequency the effect of thermal noise prevails.
|
|
|
Heavy metal contamination of selected Brno city localities
Šebková, Michaela ; Sommer, Lumír (referee) ; Dočekalová, Hana (advisor)
The aim of this work is to study the soil and plant contamination by heavy metals (lead, cadmium and mercury) in five selected places of Brno city. The sampling place Opuštěná represents the heavily polluted locality with high traffic density situated in the city centre. Sampling places Vídeňská and Podstránská belong to medium polluted localities, that are situated close to frequented roads. Relatively clean localities are represented by Musorgského and Šrámkova places, which are situated in peripheral city district with smaller traffic density. Soil and plants were sampled at two time periods (November 2008 and January 2009). Average amounts of mercury, cadmium and lead in collected soil samples are lower then limits of the Directive number 13/1994 of the Code of Ministry of the Environment. The content of heavy metals in soils corresponds to the sampling place. The highest value of metals content was found in the soil sampled at Opuštěná site. The content of lead and mercury in leaves of common dandelion was higher than the content in roots. In the case of cadmium the situation was opposite, the highest content was measured in underground part of the plant. It was found, that the content of heavy metals in leafy and underground part showed only small difference between sampling places. Nevertheless, the locality Opuštěná is found again as the highest contaminated place. Values of pH of collected soil samples were ranged in neutral area between 7 and 7,5.
|
|
|
Use of pollution indices for evaluation of soil contamination
Čmelíková, Dorota ; Pavlovský, Jiří (referee) ; Doležalová Weissmannová, Helena (advisor)
This thesis focuses on heavy metal contamination of soil and the use of pollution indices for its evaluation. Two regions were selected for assessment and comparison. The chosen heavy metals were mercury, zinc, copper, lead and cadmium. These heavy metals were analysed in 15 samples from Kyjov nad 15 samples from Ostrava. Methods of analysis were AMA-254 and FAAS. The established concentrations were used to calculate pollution indices and for health risk assessment. Pollution in Kyjov was assessed as low to medium without any health risks. Ostrava region was assessed as moderately to highly polluted with a low health risk, especially for children.
|
|
|
Analysis of noise characteristics of radioactive emission detectors
Šik, Ondřej ; Pfeifer, Václav (referee) ; Andreev, Alexey (advisor)
The main goal of this Master’s thesis is to describe relationship between low frequency noise spectral characteristics of Cadmium-Telluride radiation detectors depending on applied voltage and detectors reaction to illumination of various wavelengths. Also, the reaction and influence of higher operating temperatures were investigated. The noise measurements shown that the dominant noise type at low frequencies is the 1/f noise. Several samples with different resistivity were tested. By comparing results, we are able to estimate the quality of detectors and their sensibility to illumination and higher operating temperatures. We have found that all the studied CdTe detectors are sensitive to one particular wavelength of 548nm. Resulting data were processed by EasyPlot program that provided graphical representation of spectral noise characteristics. All measured characteristics of tested samples are compared and it’s estimated the similarity between the samples.
|
|
| |
guest ::
