|
|
Adjustable source feeded and controlled by USB bus
Staněk, Miroslav ; Frýza, Tomáš (referee) ; Kolouch, Jaromír (advisor)
The aim of this bachelor’s thesis is concept and realization of voltage source which is controlled and feeded by Universal Serial Bus. There will be presented whole design, execution, development progress and finalization of this project in the following text. This source must boost and buck standard voltage from USB. So it will be necessary using two source lines. Microcontroller of AVR family will be used in the direct part of this adjustable source. Into this microcontroller will be embedded USB interface by the software solution. The microcontroller isn‘t used only for communication with PC by the computer programme, but it is also used for switching the source lines by the PWM modulation. According to the minimum output voltage scale (0 – 15 V) this source is useful for a wide spectrum of low- power devices. This equipment could be helpful together with laptop to charging devices (cell phone, camera, pocket osciloscope etc.), which are carried with notebook for doing outdoor activities and measurements.
|
|
| |
|
|
USB miltimeter with microprocessor
Samek, Martin ; Kolka, Zdeněk (referee) ; Kovář, Jan (advisor)
Topic of my terminal labour is a proposion of multimeter and its resulting connection by the help of bus USB. When proposing the multimeter there was a tendency to use a minimal number of component parts to conserve a good protection against a bad usage in application. The most widespread busbar USB is used for connection of the multimeter and a computer. Standard HID is used for communication, for that it is not neccessary to install any system drivers.
|
|
|
Compact datalogger with flash memory
Vágner, Martin ; Hynčica, Ondřej (referee) ; Bradáč, Zdeněk (advisor)
This thesis deals with design of small datalogger with flash memory card. At first are discussed parameters, functions and features of dataloggers. The second part deals with a problem of digital measurement of analog signals. The rest of this thesis gives attention to main goal which is design of datalogger. It consists of circuit diagram, layout of printed circuit board, firmware for microcomputer and software for PC.
|
|
|
USB communication protocol analysis
Zošiak, Dušan ; Fujcik, Lukáš (referee) ; Šteffan, Pavel (advisor)
Tato práce je zaměřena na zpracování a analýzu USB komunikačního protokolu a implementace jeho jednotlivých částí do FPGA obvodu s využitím programovacího jazyka VHDL. Ve finální podobě by měla práce představovat souhrnný a ucelený dokument popisující principy USB rozhraní a jeho komunikace doplněných praktickým návrhem v jazyce VHDL, který by byl schopen převést data do USB.
|
|
|
Control of the communication on the USB
Hlavica, Zdeněk ; Michálek, Václav (referee) ; Prokeš, Aleš (advisor)
The aim of Master’s thesis Control of the communication on the USB is realization hardware and software designed for microcontroller C8051F120 what is enabling recording of data on memory medium Flash drive. It includes study of USB, transfer protocols, which are needed and file system. The thesis deals about host type USB controllers and about USB controller MAX3421E fy Maxim, which has been choosen for development of software. It is required ability to create directories and files including recording data to file and ability of reading data from files in the file system FAT16.
|
guest ::
