|
|
Research on the content of risk elements in the material of PET bottles
Kryštofová, Petra ; Řezáčová, Veronika (referee) ; Komendová, Renata (advisor)
This thesis deals with the research of the content of risk elements in the material of rPET (recycled polyethylene terephthalate), supplied from various countries, and the study of different factors (type of liquid, temperature) on the migration of antimony from this material. The recycling process has the potential to increase the content of unwanted substances and promote the formation of degradation products of chemical additives and by-products of polymerization, thus contributing to higher migration of these substances into food or food simulants [1]. The supplied rPET samples were subjected to total decomposition in an environment of concentrated sulfuric and nitric acid under the influence of microwave radiation prior to analysis. Prepared samples were analyzed by atomic absorption spectroscopy (AAS) techniques. The contents of Sb and Zn were determined by flame atomic absorption spectrometry (FAAS), and the concentrations of Pb, Cu, Zn, Cd, Cr, and Ni were determined by electrothermal atomic absorption spectrometry (ETAAS). Additionally, the concentrations of Sb were determined by this method in migration experiments. This thesis builds upon the author's bachelor's thesis, which included pilot experiments.
|
|
|
Study of properties of UV-photochemical generation of volatile compounds od antimony
Adámková, Dominika ; Červený, Václav (advisor) ; Hraníček, Jakub (referee)
The master thesis deals with comparison of atomic fluorescence spektrometry and high resolution continuum source atomic absorption spektrometry for three methods generation of volatile compounds Antimony. In both methods of atomic antimony detection, it compares the most common chemical generation of volatile compounds (hydrides) with two alternative methods - electrochemical and UV - photochemical. The values of performance parameters for the determination of Sb(III) and Sb(V) were determined for all the above combinations. In the case of chemical generation, a surprisingly almost four times higher limit of detection of Sb(III) was found in connection with AFS detection than AAS detection. The final part was devoted to UV - photochemical vapor generation, with AAS detection for Sb(III) reaching limit of detection 4,96 ppb, for Sb(V) 8,63 ppb. Although UV - photochemical generation of volatile antimony compounds did not reach such performance parameters as chemical or electrochemical generation, it was observed that the sensitivity of antimony determination increased greatly when introducing oxygen into the apparatus. The interference study also found a significant positive effect of Fe(II) on the generation efficiency, and this modification partially persisted without further introduction of these...
|
|
| |
|
|
Interferences in determination of antimony by electrochemical generation of volatile compounds and atomic fluorescence spectrometry
Kostúrová, Dominika ; Červený, Václav (advisor) ; Nováková, Eliška (referee)
Antimony is a highly toxic element that enters the environment through natural processes and human activities as well. It is necessary to determine its ultra-trace amounts in various materials such as water, soil and biological samples. Due to the heterogeneity of sample matrices, the determination of antimony is problematic because of frequent interactions. The aim of this work was to investigate the effects of various interferents on the determination of antimony by electrochemical generation of volatile compounds and atomic fluorescence spectrometry. In total, 18 interference dependencies were measured in the determination of Sb(III) and Sb(V). The following ions were selected for the interference study: SO4 2- , Cl- , NO3 - , NO2 - , Fe3+ , Fe2+ , As3+ , Se4+ and Bi3+ . The As3+ ion had the most interesting course of all the interferents and could be used as a suitable additive to increase the sensitivity of antimony determination.
|
|
|
Interferences in determination of antimony by UV-photochemical generation of volatile compounds and atomic fluorescence spectrometry
Kračmarová, Aneta ; Červený, Václav (advisor) ; Hraníček, Jakub (referee)
This work is focused on the study of interferents of selected elements during UV-photochemical generation of volatile antimony compounds. The interferents included transition metals, halides, hydride-forming elements and salts of mineral acids. Detection was performed by atomic fluorescence spectrometry. Some of the tested added substances proved to be potential reaction modifiers; in their presence, an increase in responses was observed. The best results were obtained using Fe3+ for the determination of Sb3+ and SO4 2- had the best results for the determination of Sb5+ . The largest interferent, i.e. the substance causing the most significant decrease in signal, was for both antimony ions Se4+ .
|
|
|
The study of PET bottles in terms of the content of risk elements
Kryštofová, Petra ; Řezáčová, Veronika (referee) ; Komendová, Renata (advisor)
This bachelor thesis deals with the issue of PET bottles in terms of the possible content of risk elements. The contents of antimony, copper and lead were determined in the PET packaging material and in the beverages contained in the bottles. A total of 15 samples of bottled still and infant water available in the Czech sales network were analyzed. The PET material was decomposed in an acidic medium under the action of microwave radiation under optimized conditions. Atomic absorption spectrometric methods with flame or graphite cuvette atomization were used to determine selected risk elements based on the predicted analyte concentrations. In the PET packaging material, 159.35 to 265.68 mgkg-1 of antimony were determined, the determined values of lead concentration were in the range of 10.96-20.23 mg·kg-1 and the copper concentration in the range of 0.11-7,52 mg·kg-1. In bottled water and in bottled infant water, antimony was identified only in samples labeled 6a, 8a, 9a and 15a, all lead concentrations were measured below LODPb, copper was determined only in samples 2a, 6a and 8a. In none of the samples did the concentrations given by the valid legislation be exceeded. The limits of these metals are not set in legislation in the packaging materials, only specific migration limits and they have not been exceeded. However, the high concentration of antimony in PET poses a potential risk of contamination of the contents of these packages.
|
|
|
Determination of selected metals in tea samples and bag materials
Hlávka, Jan ; Nováková, Eliška (advisor) ; Hraníček, Jakub (referee)
This bachelor thesis is dealing with determination of antimony in materials modern pyramid-shape tea bags. Possible presence of antimony in these materials, e.g. polyethylene terephthalate (PET) or mixed materials, is caused by using it like catalyst in production of polyethylene terphthalete. The goal of this bachelor thesis is the verification of hypothesis, that antimony is present in materials of pyramide tea bags and that it is released to consumed drink, if higher concentration of antimony is present, and that it could pose a health risk to the consumer. At the same time, I studied if tea leaves are contaminated by other toxic elements, from which some can result from intesive agricultural production. They can be used as pesticides or be presnet in industrial fertilizers. In this thesis I examined the content of As, Cd, Cu, Sb and Zn in tea leaves sold in pyramide bags. These pyramide bags were purchased in local supermarkets and shops. The content of Sb in bags was determined too. The applied method included the decomposition of samples in a microwave decomposition device and analysis of the composition of the resulting solution by the ICP-MS method. Determined contents of the investigated elements were expressed like content of element in the sample in dry mass and the results were compared...
|
|
|
Effect of lead and antimony on the degradation of graphite shape in cast iron
Hlobil, Albert ; Kaňa, Václav (referee) ; Záděra, Antonín (advisor)
The bachelor thesis focuses on the effect of lead and antimony on the degradation of graphite in cast iron in relation to the lowered mechanical characteristics. This leads to the subsequent summary of the formation of degraded structures and unfavourable elements – the elements that are the cause of the formation. In the practical segment of the thesis, I will prove the effects of lead (or the combination of lead and antimony) on the degradation of graphite in cast iron with the focus lying at flake graphite. Furthermore, the thesis examines the mechanical characteristics and the attenuation of cast iron in relation to the formation of degraded graphite structures.
|
|
|
Study of properties of UV-photochemical generation of volatile compounds od antimony
Adámková, Dominika ; Červený, Václav (advisor) ; Hraníček, Jakub (referee)
The master thesis deals with comparison of atomic fluorescence spektrometry and high resolution continuum source atomic absorption spektrometry for three methods generation of volatile compounds Antimony. In both methods of atomic antimony detection, it compares the most common chemical generation of volatile compounds (hydrides) with two alternative methods - electrochemical and UV - photochemical. The values of performance parameters for the determination of Sb(III) and Sb(V) were determined for all the above combinations. In the case of chemical generation, a surprisingly almost four times higher limit of detection of Sb(III) was found in connection with AFS detection than AAS detection. The final part was devoted to UV - photochemical vapor generation, with AAS detection for Sb(III) reaching limit of detection 4,96 ppb, for Sb(V) 8,63 ppb. Although UV - photochemical generation of volatile antimony compounds did not reach such performance parameters as chemical or electrochemical generation, it was observed that the sensitivity of antimony determination increased greatly when introducing oxygen into the apparatus. The interference study also found a significant positive effect of Fe(II) on the generation efficiency, and this modification partially persisted without further introduction of these...
|
|
|
Fabrication and characterization of oxidic conductive layers
Bartoš, Radim ; Gemeiner,, Pavol (referee) ; Dzik, Petr (advisor)
Liquid composition for antimony doped tin oxide solgel deposition was prepared. Anorganic precursors of tin and antimony were used (tin(IV) chloride, antimony(III) chloride). ATO nanoparticles were dispergated in composition. This composition was used for spincoating deposition of thin films. Composition was analyzed by thermal analysis TGA and DSC. Sheet resistence of prepared samples were examined by four probe sensing. RMS roughness and thickness was measured by profilometry. Samples were analyzed by scan electron microscopy (SEM), X-ray diffraction (XRD) and X-ray photoelectron spectroscopy (XPS). Transmittance and haze were measured and calculated by UV-VIS spektrometry with integration sphere.
|
guest ::
