| |
|
Nanoscale phases on surface Fe-6Si magnetic sheets
Švábenská, Eva ; Roupcová, Pavla ; Král, Lubomír ; Bulín, Tomáš ; Vondráček, Martin ; Foldyna, Josef ; Čechal, J. ; Schneeweiss, Oldřich
Analysis of the nanoscale phases which appear on the surface Fe-6Si samples were carried out after the various treatments – grinding and etching, annealing, and water jet abrasion. The basic information on structure, chemical and phase composition was obtained by X-Ray Powder Diffraction (XRD), Scanning Electron Microscopy with EDX, Glow Discharge Optical Emission Spectrometry (GDOES), Mössbauer Spectroscopy and X-ray Photoelectron Spectrometry (XPS). The results show high stability of the surface phase composition after the mechanical and heat treatments. Results obtained from the surface analysis in micrometer depth (XRD, EDX, GDOES) do not show any changes after the different treatments. Iron oxides were detected in XPS and conversion electron Mössbauer spectra (CEMS) which analyze the surface composition in a nanometer scale. In addition to, fine changes in atomic ordering on the surface can be observed after mechanical and heat treatments in the CEMS spectra.
|
|
HYDROGENATION OF CHOSEN MgMXN INTERMETALLICS (X=Al, Ga, In, Si, Sn)
Čermák, Jiří ; Král, Lubomír ; Roupcová, Pavla
Hydrogen sorption in chosen intermetallics MgmXn (Mg17Al12 , Mg2Ga, mixture of beta-Mg-In phases, Mg2Si and Mg2Sn) formed by magnesium and elements from the 13 th (X: Al, Ga, In) and 14 th (X: Si, Sn) groups was studied between the room temperature and T = 350 °C. Hydrogen pressure p varied from 10-3 MPa to 6 MPa.\nHydrogen solubility in alpha phase (solid solution of hydrogen in MgmXn before the hydride phase was nucleated) was close to hydrogen solubility in pure Mg. Concentration cH of hydrogen solved in Mg m X n depended linearly on pressure p , dependence of cH on temperature T was relatively weak. MgH2 was the main hydrogen storage phase in all the compounds MgmXn . Nucleation of MgH2 at 350 °C was observed at pressure above approximately 1 MPa in Mg17Al12 and above 2 Ma in other compounds. Maximum values of c H in hydride-containing compounds MgmXn detected at T = 350 °C depended on the stability of MgmXn .
|
|
HYDROGENATION PROPERTIES OF Mg-Al-Ti-Zr-C COMPOSITE
Král, Lubomír ; Čermák, Jiří ; Roupcová, Pavla
The improvement of hydrogen storage properties of ball-milled Mg-Al-Ti-Zr-C composite was studied in this\npaper. It has been previously shown, that the addition of Ti, Zr, Al and C improves storage properties of Mg.\nThis beneficial effect of additives upon hydrogen storage properties can be explained by catalysis by the\nnanoparticles rich in Ti, Zr or Al located on the surface of Mg grains. They provide effective pathways for the\nhydrogen diffusion into the MgH2. The morphological and microstructural characteristics were investigated by\nscanning electron microscope Tescan Lyra 3 and by X-ray diffraction. The hydrogen sorption was measured\nby Sieverts method using Setaram PCT-Pro device.\nStudied experimental composite absorbed 4.2 wt.% H 2 at 573 K and 3 wt.% H 2 at 523K within 10 min. The\nhydrogen storage capacity of the composite was about 4.6% wt.% H 2 and 4.2% wt.% H 2 at 573K and 523K,\nrespectively.
|
|
Magnetic properties of 42CrMo4 steel
Bulín, T. ; Švábenská, Eva ; Hapla, Miroslav ; Roupcová, Pavla ; Ondrušek, C. ; Schneeweiss, Oldřich
Low alloyed high-grade chrome-molybdenum ferritic steel was investigated from the point of views of magnetic properties in dependence on heat and mechanical treatment. This steel can be used as components of magnetic circuits or some parts in electrical equipment. The basic information on structure and phase composition was obtained by optical and scanning electron microscopy, X-ray Powder Diffraction and Mössbauer Spectroscopy. The temperature stability of the material was proved by measurements of temperature dependences of magnetic moment. The magnetic parameters were obtained by measuring of magnetic hysteresis loops in dependence on saturation field and their frequencies. The results are discussed from the point of view of possible applications as a magnetic material in the very extremely environment, where high mechanical stresses and elevated temperatures can occur.
|
| |
|
Chemical Wet Synthesis and Characterization of Copper-Silver Nanoparticles
Zobač, O. ; Sopoušek, J. ; Vykoukal, V. ; Buršík, Jiří ; Roupcová, Pavla
AgCu nanoparticles (NPs) of near-eutectic composition were prepared by various route of wet synthesis. Nanoparticles suspended in nonpolar solvents were synthesized by solvothermal synthesis from metalloorganic precursors. AgCu colloids in aqueous solution were obtained by the hydride reduction of Ag and Cu nitrates under action of different stabilization agents. Chemical characterizations of as-synthesized AgCu NPs were done using inductively-coupled plasma-optical emission spectrometry (ICP-OES). The optical properties of nanoparticles were monitored using UV-Vis spectrophotometer. The size of colloid nanoparticles were measured by both dynamic light scattering (DLS) and small angle X-ray scattering (SAXS) method in some extra cases.
|
|
HYDROGENATION PROPERTIES OF BALL-MILLED Mg-Ti-C-Zr COMPOSITE
Král, Lubomír ; Čermák, Jiří ; Roupcová, Pavla
The hydrogen storage properties of ball-milled Mg-Ti-Zr-C composite (1.8 wt.% Ti, 1.9 wt.% Zr and 0.2 wt.% C) were investigated. It has been previously shown, that the addition of Ti, Zr and C improved its storage properties. This beneficial effect of additives upon hydrogen storage properties can be explained by catalysis by the particles rich in Ti or Zr located on the surface of Mg grains. They provide effective pathways for the hydrogen diffusion into the MgH2. The morphological and microstructural characteristics were investigated by scanning electron microscopy and by X-ray diffraction. The hydrogen sorption was measured by Sieverts method using Setaram PCT-Pro device. In this paper, sorption behaviour of the composite after ball-milling and after aging on the air was compared. The ball-milled composite adsorbed 3.5 wt.% H2 within 10 min at 623 K. However, hydrogen storage capacity of the composite aged on the air for 7 months remarkably decreased: The aged composite adsorbed within 10 min only 2 wt.% H2 at 623 K and the sorption capacity decreased from 4.7 wt.% H2 to 2.1 wt.% H2.
|
|
Changes in structure and phase composition in the surface of tram rail
Švábenská, Eva ; Roupcová, Pavla ; Schneeweiss, Oldřich
We have investigated structure and phase composition of surface layer of tram rails after long time running and the results were compared with those obtained on the original part of material. Changes due to effects of severe plastic deformation together with thermal shocks by friction process were expected. The information about structure and phase composition was obtained by optical and scanning electron microscopy, X-Ray Powder Diffraction, Mössbauer Spectroscopy and Glow Discharge Emission Spectroscopy (GDOES) and this was completed by microhardness measurements. The results show that the surface layer in comparison with the original material exhibits important changes in grain structure, an increase in microhardness and high content of iron oxide and hydrooxides. According to the depth profile of the chemical composition measured by GDOES there is an increase in carbon content in the surface layer which can be effect of up-hill diffusion.
|
|
HYDROGEN ABSORPTION IN A-Co30Fe55B15
Čermák, Jiří ; Král, Lubomír ; Roupcová, Pavla
Hydrogen solved in amorphous alloys (AAs) influences their magnetic characteristics. AAs are also perspective\nas additives that can improve hydrogen storage kinetic in certain types of ball-milled hydrogen storage\nmaterials (HSMs). Therefore, knowledge of hydrogen solubility and hydrogen sorption kinetics in AAs are of a\ngreat importance for aimed design both AAs with optimal magnetic parameters and HSMs with desired sorption\ncharacteristics. In the present paper, amorphous alloy Co30Fe55B15 (an example of the type a-TM1xTM2y Bz ;\nTM - transition metal) was investigated. Hydrogen concentration c H was measured by Sieverts method in\ntemperature interval from T = 150 °C to T = 350 °C under hydrogen pressure p up to 6 MPa. It was found that\nc H was an increasing function of p and its maximum value was typically 0.5 wt.% H2 at 350 °C and 6 MPa.\nHowever, when the alloy was preliminary hydrogen charged (PHC), the pressure dependence of total c Htot in\nthe first absorption cycle(s) is non-monotonous in dependence on PHC conditions. For the sake of comparison,\nthe same absorption characteristics were measured also in Mg2Ni intermetallic that is a common constituent\nin Mg-based HSMs. Comparing Co30Fe55B15 and Mg2Ni, it was concluded that Co30Fe55B15 shows lower\nhydrogen solubility, but much better absorption kinetics.
|