|
|
Surface morphology of a-CSi:H films prepared from tetravinylsilane in low-temperature plasma
Křípalová, Kristýna ; Pálesch, Erik (referee) ; Čech, Vladimír (advisor)
This bachelor thesis is focused on the surface morphology of a-CSi:H films. Films were prepared by plasma-enhanced chemical vapor deposition (PECVD) on silicon wafers using plasma discharge. Tetravinylsilane (TVS) precursor was used for deposition. The set of samples deposited at different effective power (2-150 W) and a thickness of about 0.6 µm was characterized to investigate their surface properties. Atomic force microscopy was used for characterization of surface morphology. Obtained results were used for evaluation of surface roughness and assessment of the effect of the film growth dynamics on the surface topography.
|
|
|
Exoscopy of sediments of glacigenous accumulation landforms
Křížová, Lenka ; Křížek, Marek (advisor) ; Lisá, Lenka (referee)
This thesis looks at the comparison between grain micromorphology of moraines, debris flows and similar accumulations. Moraine samples were taken in the Černé jezero Lake area, Bohemian Forest, in the Velická dolina Valley, High Tatras, and in the Labský důl Valley, Krkonoše Mts. Samples of debris flows and unverified accumulations were taken in the Důl Bílého Labe Valley, Krkonoše Mts., and further samples of accumulations were obtained from the valley of Prudký potok Stream, Králický Sněžník Mts., the valley of Vražedný potok Stream and Velká Kotlina, Hrubý Jeseník Mts. Sediments were examined under electron microscope and their morphological characteristics and influence of the environment were identified and described. Calculated exoscopic moraine standard was used for comparison of examined forms of relief using distance coefficients, statistical analysis were carried out which identified diagnostic characters for distinguishing moraines and debris flows. There was also calculated exoscopic standard for different types of moraines (frontal, lateral, basal). This research highlighted the differences between moraines and debris flows, and between different types of moraines. The study also proved that typical glacial microtextures, that are generally accepted, occur at similar levels on grains...
|
|
|
Exoscopy of sediments of glacigenous accumulation landforms
Křížová, Lenka
This thesis looks at the comparison between grain micromorphology of moraines, debris flows and similar accumulations. Moraine samples were taken in the Černé jezero Lake area, Bohemian Forest, in the Velická dolina Valley, High Tatras, and in the Labský důl Valley, Krkonoše Mts. Samples of debris flows and unverified accumulations were taken in the Důl Bílého Labe Valley, Krkonoše Mts., and further samples of accumulations were obtained from the valley of Prudký potok Stream, Králický Sněžník Mts., the valley of Vražedný potok Stream and Velká Kotlina, Hrubý Jeseník Mts. Sediments were examined under electron microscope and their morphological characteristics and influence of the environment were identified and described. Calculated exoscopic moraine standard was used for comparison of examined forms of relief using distance coefficients, statistical analysis were carried out which identified diagnostic characters for distinguishing moraines and debris flows. There was also calculated exoscopic standard for different types of moraines (frontal, lateral, basal). This research highlighted the differences between moraines and debris flows, and between different types of moraines. The study also proved that typical glacial microtextures, that are generally accepted, occur at similar levels on grains...
|
|
|
Surface morphology of a-CSi:H films prepared from tetravinylsilane in low-temperature plasma
Křípalová, Kristýna ; Pálesch, Erik (referee) ; Čech, Vladimír (advisor)
This bachelor thesis is focused on the surface morphology of a-CSi:H films. Films were prepared by plasma-enhanced chemical vapor deposition (PECVD) on silicon wafers using plasma discharge. Tetravinylsilane (TVS) precursor was used for deposition. The set of samples deposited at different effective power (2-150 W) and a thickness of about 0.6 µm was characterized to investigate their surface properties. Atomic force microscopy was used for characterization of surface morphology. Obtained results were used for evaluation of surface roughness and assessment of the effect of the film growth dynamics on the surface topography.
|
|
|
Influence of surface morphology on fatigue behavior of metastable austenitic stainless steel AISI 347 at ambient temperature and 300°C
Smaga, M. ; Skorupski, R. ; Mayer, P. ; Kirsch, B. ; Aurich, J. C. ; Raid, I. ; Seewig, J. ; Man, Jiří ; Eifler, D. ; Beck, T.
The effect of surface modification by cryogenic turning on fatigue behavior of metastable austenitic stainless steel AISI 347 was investigated in stress-controlled fatigue tests at ambient temperature (AT) and 300 °C in air. Five different surface morphologies were manufactured by the variation of turning parameters. Surface and near surface morphology were comprehensively characterized by various experimental techniques. The experimental data on the cyclic deformation behavior, stress-strain response and fatigue life for all surface morphologies are reported.
|
|
|
Exoscopy of sediments of glacigenous accumulation landforms
Křížová, Lenka
This thesis looks at the comparison between grain micromorphology of moraines, debris flows and similar accumulations. Moraine samples were taken in the Černé jezero Lake area, Bohemian Forest, in the Velická dolina Valley, High Tatras, and in the Labský důl Valley, Krkonoše Mts. Samples of debris flows and unverified accumulations were taken in the Důl Bílého Labe Valley, Krkonoše Mts., and further samples of accumulations were obtained from the valley of Prudký potok Stream, Králický Sněžník Mts., the valley of Vražedný potok Stream and Velká Kotlina, Hrubý Jeseník Mts. Sediments were examined under electron microscope and their morphological characteristics and influence of the environment were identified and described. Calculated exoscopic moraine standard was used for comparison of examined forms of relief using distance coefficients, statistical analysis were carried out which identified diagnostic characters for distinguishing moraines and debris flows. There was also calculated exoscopic standard for different types of moraines (frontal, lateral, basal). This research highlighted the differences between moraines and debris flows, and between different types of moraines. The study also proved that typical glacial microtextures, that are generally accepted, occur at similar levels on grains...
|
|
|
Exoscopy of sediments of glacigenous accumulation landforms
Křížová, Lenka ; Křížek, Marek (advisor) ; Lisá, Lenka (referee)
This thesis looks at the comparison between grain micromorphology of moraines, debris flows and similar accumulations. Moraine samples were taken in the Černé jezero Lake area, Bohemian Forest, in the Velická dolina Valley, High Tatras, and in the Labský důl Valley, Krkonoše Mts. Samples of debris flows and unverified accumulations were taken in the Důl Bílého Labe Valley, Krkonoše Mts., and further samples of accumulations were obtained from the valley of Prudký potok Stream, Králický Sněžník Mts., the valley of Vražedný potok Stream and Velká Kotlina, Hrubý Jeseník Mts. Sediments were examined under electron microscope and their morphological characteristics and influence of the environment were identified and described. Calculated exoscopic moraine standard was used for comparison of examined forms of relief using distance coefficients, statistical analysis were carried out which identified diagnostic characters for distinguishing moraines and debris flows. There was also calculated exoscopic standard for different types of moraines (frontal, lateral, basal). This research highlighted the differences between moraines and debris flows, and between different types of moraines. The study also proved that typical glacial microtextures, that are generally accepted, occur at similar levels on grains...
|
guest ::
