| |
| |
|
PIV měření 2D modelu ventilu Doosan s řízením proudění
Uruba, Václav ; Procházka, Pavel P. ; Skála, Vladislav
Zpráva obsahuje výsledky měření na modelu ventilu s řízením proudění pro firmu Doosan. Jako vzor pro model ventilu sloužil typický ventil používaný pro regulaci páry ve vstupním potrubí parní turbíny. Řízení je prováděno vkládáním usměrňovacích prvků a vyfukováním vzduchu ze slotů. Účelem studie je zhodnotit různé způsoby řízení proudění ve ventilu z hlediska ovlivnění odtržení mezní vrstvy v difuzoru.
|
|
Coanda effect in valves
Uruba, Václav ; Procházka, Pavel P. ; Skála, Vladislav
Coanda effect takes place in flow within valves diffuser for certain conditions. The valve plug in\nhalf-closed position forms wall-jet, which could be stable or instable, depending on geometry and other\nconditions. This phenomenon was subject of experimental study using time-resolved PIV technique. For the acquired data analysis the special spatio-temporal methods have been used.
|
| |
|
Intermitence factor evaluation by bypass boundary layer transition in flows on rough surface on flat plate
Skála, Vladislav ; Antoš, Pavel
Bypass boundary layer transition in flows on rough surface on flat plate was investigated experimentally. It was measuered cases with combination of roughness of surface by different free stream turbulence intenzity. Hot wire anemometry technique was used. Measuerement were made on flat plate in closed wind tunnel. Flat plate was covered by different roughness foils (sandpapers). Adverse pressure gradient was set by diffuser in tested section of wind tunnel. Grid turbulence of free stream was controlled by grid. Hot wire anemometry technique was used, intermitency factor was evaluated.
|
|
Experimental Investigation of The Flow Pattern Behind Cylinder
Vítkovičová, R. ; Skála, Vladislav ; Čížek, J.
Investigation of the flow behind bluff bodies, especially for cylinder, is one of the highly topical research topics in the fluid mechanics. Nevertheless, mainly because of its complexity, this topic is still an open problem. This article discusses the running project at the Czech Technical University in Prague, Faculty of Mechanical Engineering and it deal with the implementation of a methodology for measuring the cylinder wake in a wind tunnel and also recapitulates the partial results obtained measurements.
|
|
Optimalizovaná pětiotvorová sonda
Skála, Vladislav ; Pick, P. ; Nožička, J.
Práce se zabývá návrhem, konstrukcí a stanovením charakteristik pětiotvorové sondy pro měření směru a velikosti rychlosti proudu vzduchu v aerodynamickém tunelu. Sonda byla při návrhu optimalizována. Stanovené charakteristiky budou použity při vyhodnocování rychlosti měřených touto sondou.
|
| |