|
|
Determination of Te(IV) by photochemical generation of volatile compounds with atomic spectrometric detection
Ruxová, Helena ; Hraníček, Jakub (advisor) ; Šíma, Jan (referee)
This thesis deals with the development of a method suitable for determination Te(IV) by UV-photochemical generation of volatile compounds (UV-PVG) in liquid samples. Atomic absorption spectrometry (AAS) and atomic fluorescent spectrometry (AFS) were used as detection methods. The basis of the apparatus for UV-PVG was a mercury lamp wrapped by PTFE capillary. Firstly, the experimental parameters were optimized for both methods. The optimized parameters were the type, concentration, pH and flow rate of the reaction medium, the length of the PTFE reaction coil, carrier gas flow rate (argon), supportive gas flow rate (hydrogen) and atomization temperature. The figures of merit with both detection methods were determined and compared after the method was optimized. Detection limits achieved for these two detection methods were 6,0 µg dm-3 for AFS and 1,50 µg dm-3 for AAS. Performed interference study confirmed a significant effect of many cations of transition metals and hydride forming elements on tellurium determination. The influence of nitric acid in the sample was studied separately. The suitability of the method for tellurium determination was confirmed by using a spiked certified reference material.
|
|
|
Switchable Filter For UHF Band
Sedlák, Milan
The contribution deals with the design of a multi-channel switchable filter for ultra high frequency band. The device is primarily designed for the system of sensors which are used for detection of the electromagnetic pulses. They are emitted by the partial discharges in power transformers as a consequence of aging of the dielectric. The main task of the multi-channel switchable filter is to ensure better reliability of the entire system by filtering of undesirable signals with lower frequencies content which are usually products of the external and internal disturbance.
|
|
|
A Method to Supress Interferences in Wigner-Ville Distribution
Pikula, Stanislav ; Pazdera, Luboš (referee) ; Hájek, Karel (referee) ; Beneš, Petr (advisor)
The doctoral thesis focuses on signal representation in the time-frequency domain with constant resolution. In theoretical introduction the possibilities of displaying a signal in time and frequency are summarized. Attention is concentrated on comparison of short-time Fourier Transform (STFT) and Wigner-Ville Distribution (WVD). The latter achieves a significantly better resolution, especially for a linearly modulated signal. The disadvantage of WVD, which is the presence of interferences resulting from the calculation of the instantaneous autocorrelation function, is described in detail. These interferences are due to the presence of multiple components in the signal or its non-linear modulation. Subsequently, several methods are discussed, which can suppress these interferences, but at the cost of resolution loss. One of the interference suppression methods is smoothed pseudo Wigner-Ville distribution. It is further used in this thesis for the analysis of interference suppression when various filtrations in the time-frequency plane are applied. Several signals with multiple components or various non-linear modulations are used. Based on the analysis, a method using a set of variously smoothed pseudo Wigner-Ville distributions is designed to estimate the time-frequency representation with high resolution and minimal interferences. To compare the results to other methods, the quantitative metrics used in the literature are compared. To select the appropriate one a new metric is suggested. It is applicable to simulated signals and uses mean square error. Based on the comparison, the Stankovi\'{c} measure is selected as the most appropriate for comparing results. The selected metric is used to determine the appropriate minimal number of differently smoothed pseudo Wigner-Ville distributions. Using the selected metric, the proposed method is compared with other methods. These are STFT with optimized window length, S-method with optimized parameter and optimization method using radial Gaussian kernel (RGK). These methods are compared based on the set of signals previously used for interference suppression analysis. In addition, noises are added to the signals. Finally, the methods are also compared based on the real bat echo signal. In conclusion, the proposed method outperforms the compared methods in suppressing interference and resolution.
|
|
|
Speciation analysis of arsenic and mercury using postcolumn generation of their volatile compounds for needs of atomic spectroscopic methods
Linhart, Ondřej
The presented dissertation thesis deals with the use of UV-photochemical generation of volatile compounds (UV-PVG) as a derivatization technique for the combination of high-performance liquid chromatography (HPLC) and atomic absorption spectrometry (AAS) detection. Two model elements arsenic and mercury and their compounds were selected for the speciation analysis. The work was divided into several parts that follow. In the first part of the research, the apparatus for the UV-photochemical generation of the volatile mercury compounds and their detection with a new continuum source and high-resolution atomic absorption spectrometer (HR-CS AAS) with an externally heated detection tube was constructed. The analytical method was adapted for use with atomic fluorescence detection with the aim to improve sensitivity of the determination. Furthermore, apparatus for the electrochemical generation of cold mercury vapor with AAS detection was built. The construction of the apparatus was followed by optimization of the reaction conditions (concentration and flow of electrochemical reagents: sulfuric and hydrochloric acid, mobile phase, carrier medium, flow rate of the carrier gas and localization of its introduction), determination of the analytical figures of merit, and comparation of the methods. Both...
|
|
|
UV-photochemical generation of volatile compounds of selenium and tellurium
Nováková, Eliška
The presented thesis deals with UV-photochemical generation of volatile compounds of Se and Te from various species. The aim of the project was to expand the current state of knowledge by the application of photocatalytic reduction of higher oxidation states of Se and Te for the speciation analysis based on UV-photochemical generation of volatile compounds. The first step of the study was the assembly of the apparatus for the photocatalysed UV-photochemical generation of volatile compounds. The material of reactor and the whole experimental set-up were based on literature survey and previous research done in our research group. Experiments were directed towards finding the optimum conditions for generation of volatile compounds of selected model elements Se and Te. Se was studied as the element most commonly determined by the UV-photochemical generation of volatile compounds. Conversely, Te was selected as a model analyte representing elements forming less stable volatile compounds. The second part was the application of the optimised method of photocatalysed UV- photochemical generation of volatile Se compound to the determination of Se in water matrices, liquid certified reference materials and also samples of dietary supplements. TiO2/UV-photochemical generation was also successfully modified to...
|
|
|
Influence Of Interferences Caused By Non-Linear
Power Amplifier In Multi-User Generalized
Frequency Division Multiplex Scenario
Harvanek, Michal
This article is aimed to the problematic of interferences in multi-user scenarios which can occur in modern mobile communication networks. Hence of new modulation schemes as a Filter Bank Multi Carrier (FBMC), Generalized Frequency Division Multiplex (GFDM) or another modulation scheme with low out of band emission there can occur problems with interferences especially when user equipments are using non-linear power amplifiers. The non-linear system causes radiation into adjacent channel which can lead to interferences with another user transmitting in this channel. This paper explains impact of such interferences to Error Vector Magnitude (EVM) of demodulated signal for different frequency spacing between users and also describe influence of interferences for different signal noise ratio. To remove inter-carrier interferences, the self interference cancellation method is used.
|
|
|
Speciation analysis of arsenic and mercury using postcolumn generation of their volatile compounds for needs of atomic spectroscopic methods
Linhart, Ondřej ; Červený, Václav (advisor) ; Spěváčková, Věra (referee) ; Šíma, Jan (referee)
The presented dissertation thesis deals with the use of UV-photochemical generation of volatile compounds (UV-PVG) as a derivatization technique for the combination of high-performance liquid chromatography (HPLC) and atomic absorption spectrometry (AAS) detection. Two model elements arsenic and mercury and their compounds were selected for the speciation analysis. The work was divided into several parts that follow. In the first part of the research, the apparatus for the UV-photochemical generation of the volatile mercury compounds and their detection with a new continuum source and high-resolution atomic absorption spectrometer (HR-CS AAS) with an externally heated detection tube was constructed. The analytical method was adapted for use with atomic fluorescence detection with the aim to improve sensitivity of the determination. Furthermore, apparatus for the electrochemical generation of cold mercury vapor with AAS detection was built. The construction of the apparatus was followed by optimization of the reaction conditions (concentration and flow of electrochemical reagents: sulfuric and hydrochloric acid, mobile phase, carrier medium, flow rate of the carrier gas and localization of its introduction), determination of the analytical figures of merit, and comparation of the methods. Both...
|
|
|
UV-photochemical generation of volatile compounds of selenium and tellurium
Nováková, Eliška ; Hraníček, Jakub (advisor) ; Komárek, Josef (referee) ; Šíma, Jan (referee)
The presented thesis deals with UV-photochemical generation of volatile compounds of Se and Te from various species. The aim of the project was to expand the current state of knowledge by the application of photocatalytic reduction of higher oxidation states of Se and Te for the speciation analysis based on UV-photochemical generation of volatile compounds. The first step of the study was the assembly of the apparatus for the photocatalysed UV-photochemical generation of volatile compounds. The material of reactor and the whole experimental set-up were based on literature survey and previous research done in our research group. Experiments were directed towards finding the optimum conditions for generation of volatile compounds of selected model elements Se and Te. Se was studied as the element most commonly determined by the UV-photochemical generation of volatile compounds. Conversely, Te was selected as a model analyte representing elements forming less stable volatile compounds. The second part was the application of the optimised method of photocatalysed UV- photochemical generation of volatile Se compound to the determination of Se in water matrices, liquid certified reference materials and also samples of dietary supplements. TiO2/UV-photochemical generation was also successfully modified to...
|
|
|
Arsenic determination in beer samples and raw materials for its preparation
Švadlenová, Veronika ; Hraníček, Jakub (advisor) ; Jelínek, Ivan (referee)
This thesis describes the optimization of the method for determination of arsenic by the chemical hydride generation coupled with AAS detection in beer samples and raw materials for its preparation. The beer usually contain arsenic at ultratrace level, however, it is necessary to monitor the concentration of this element in the beer. The routinely used method for determination of arsenic is determination by electrothermal atomization. This approach is time consuming, expensive and less sensitive. It has been developer suitable determination of arsenic as a faster and less expensive method. For this method there was optimized the flow rate of argon to 75 ml·min-1, the optimum flow rate for the reagents was 4.0 ml·min-1 and for the sample 5.0 ml·min-1 . 3 % NaBH4 in 0.5 % NaOH was used as the reducing agent for the determination of arsenic, and HCl diluted 1:1 with distilled water was used to acidify the sample. With this parameter LOD was 0.32 μg·l-1 and LOQ 1.05 μg·l-1 . It has been tested the arsenic determination in samples of barley, malt and potable water as beer raw materials. It has been found that the beer matrix is unsuitable for the hydride generation technique due to a stormy reaction in the gas/liquid phase separator. The effect of pretreatment, which is likely to enhance the effect of...
|
|
|
UV-photochemical generation of volatile selenium compounds for ultratrace analysis by AAS
Rybínová, Marcela ; Rychlovský, Petr (advisor) ; Komárek, Josef (referee) ; Šíma, Jan (referee)
This thesis deals with the study of UV-photochemical generation of volatile compounds (UV-PVG) in connection with atomic absorption spectrometry (AAS). Selenium (Se(IV)) was selected as a model analyte and many experiments were carried out to expand the current sum of knowledge of the topic. The study was commenced by assembling the UV-PVG apparatus in the continuous flow mode. The detection method used was AAS with externally heated quartz furnace atomizer. The focus of the first step of the study was on the construction of the volatile compounds generator (UV-photoreactor) with emphasis on the material used; tubes made of teflon or quartz of different diameters were tested. The construction of the apparatus was followed by optimization of the reaction conditions (the type and concentration of the photochemical agent and other agents, which increase the analytical signal; the carrier gas and the auxiliary hydrogen gas flow rate; the sample flow rate). Eventually, the analytical figures of merit of the selenium determination using the proposed method were found. The results showed that teflon reaction tubes are a good competitor to those made of quartz. The accuracy of the method has been successfully verified by analysis of certified reference material and its applicability has been further tested...
|
guest ::
