|
|
Diaphragm discharge in organic dye solutions
Pajurková, Jana ; Možíšková, Petra (referee) ; Kozáková, Zdenka (advisor)
This Diploma thesis was focused on the degradation of dyes Saturn Red L4B (Direct Red 79) and Saturn Blue LB (Direct Blue 106) by DC diaphragm discharge (DC-DD). Supplied power was between 160 and 180 W. Conductivity and pH were changing at each electrode area during the DC diaphragm discharge, therefore the effect of pH and conductivity changes on the dye solution itself were examined. All samples were measured by UV-VIS spectrometer in the wavelength range of 300–800 nm. No significant dependence of dye absorption spectra on conductivity was observed, while pH significantly affected the absorption curves of dyes. Ageing of dye spectra showed significant changes of Saturn Red L4B. Next task was the comparison of dyes destruction efficiency by DC-DD, audiofrequency diaphragm discharge (AF-DD) and electrolysis. Dye decomposition by AF-DD was not observed at set conditions (voltage of 80–120 V, current of 2.2 A and frequency of 2 kHz). In the case of DC diaphragm discharge the electrolysis played an important role. Decomposition efficiency of the dyes by electrolysis was up to 15 %. The pumping effect in the DC diaphragm discharge was also investigated. Although the individual electrode areas were linked only by a small pinhole in a nonconductive barrier (the pinhole diameter of 0.3 mm), solutions of the anode and cathode compartment interacted with each other up to 10 %. Finally, the degradation products of Saturn Red L4B treated by DC-DD in two electrodes parts are also described. Decomposition products were determined by high performance liquid chromatography (HPLC) combined with the mass spectrometer.
|
|
|
Influence of electrolysis on the degradation of dye water solutions
Olexová, Barbora ; Možíšková, Petra (referee) ; Kozáková, Zdenka (advisor)
The basic subject of this thesis is to investigate the influence of electrolysis on degradation of organic dyes in aqueous solutions. Electrolysis is a physically-chemical process, during which - under the influence of direct current - chemical reactions proceed inside the system. By choosing efficient conditions it is possible to achieve fundamental changes in the structure of organic compound’s molecules and on the basis of that for example their gradual degradation. This effect can be used in the process of wastewater treatment. The main task of the thesis is to analyse the influence of variously chosen chemical and physical conditions on the rate of degradation of azo dyes, which is the largest group of organic dyes used in industry and from this reason in great amounts contained both in mill residues and sewage water. Azo dyes have been selected for this experiment for their good solubility in water. Other advantage is that their degradation is accompanied by visible decoloration of the solution and their concentration in solution can be easily determined by UV-VIS spectrometry. Concretely two direct azo dyes - C.I. Direct Blue 106 and C.I. Direct Red 79 - have been chosen. The experiment was carried out in a simple reactor consisted of a bath with a stirrer into which two electrodes were installed and attached to the source of direct voltage. Every series of measurement proceeded at constant current which values were varied in range from 100 mA to 1 000 mA. The electric voltage ranged from 7 V to 22 V. Several samples were taken away from the solution during the experiment and the decrease of dye concentration was evaluated in every series. This evaluation validated the hypothesis that the dyes contained in the solution really degraded. This process was also connected to the expected bleaching of the solution. Decoloration of aqueous solution of dye is caused by disruptions in the structure of the dye molecule which is loosing its characteristic sections that cause colourfulness (a conjugate system of double bonds and presence of appropriate substitutes). A total amount of measured series was 16 with various input conditions (Fe and Pt electrodes, electrolytes NaCl, Na2SO4, and NaNO3 and their different concentrations, different current values) which more or less influenced the rate of degradation of investigated substances. It was found out that the blue dye is more likely to be electrolytically degraded. Chemical structure of its molecules, which is smaller and less branched than molecules of the used red dye, could be the source of that. The greatest degradation of the blue one proceeded at two chosen maximum values of constant current 800 mA and 1 000 mA. It could be assumed that current enhancement through the system induces higher dye concentration decrease. Degradation of the blue dye proceeded faster by using electrodes made of stainless steel than the platinum electrodes. The most suitable electrolyte was shown to be sodium chloride. When higher concentration (or conductivity) of electrolyte was used higher efficiency of degradation process was observed.
|
|
|
Diaphragm discharge in organic dye solutions
Pajurková, Jana ; Možíšková, Petra (referee) ; Kozáková, Zdenka (advisor)
This Diploma thesis was focused on the degradation of dyes Saturn Red L4B (Direct Red 79) and Saturn Blue LB (Direct Blue 106) by DC diaphragm discharge (DC-DD). Supplied power was between 160 and 180 W. Conductivity and pH were changing at each electrode area during the DC diaphragm discharge, therefore the effect of pH and conductivity changes on the dye solution itself were examined. All samples were measured by UV-VIS spectrometer in the wavelength range of 300–800 nm. No significant dependence of dye absorption spectra on conductivity was observed, while pH significantly affected the absorption curves of dyes. Ageing of dye spectra showed significant changes of Saturn Red L4B. Next task was the comparison of dyes destruction efficiency by DC-DD, audiofrequency diaphragm discharge (AF-DD) and electrolysis. Dye decomposition by AF-DD was not observed at set conditions (voltage of 80–120 V, current of 2.2 A and frequency of 2 kHz). In the case of DC diaphragm discharge the electrolysis played an important role. Decomposition efficiency of the dyes by electrolysis was up to 15 %. The pumping effect in the DC diaphragm discharge was also investigated. Although the individual electrode areas were linked only by a small pinhole in a nonconductive barrier (the pinhole diameter of 0.3 mm), solutions of the anode and cathode compartment interacted with each other up to 10 %. Finally, the degradation products of Saturn Red L4B treated by DC-DD in two electrodes parts are also described. Decomposition products were determined by high performance liquid chromatography (HPLC) combined with the mass spectrometer.
|
|
|
Influence of electrolysis on the degradation of dye water solutions
Olexová, Barbora ; Možíšková, Petra (referee) ; Kozáková, Zdenka (advisor)
The basic subject of this thesis is to investigate the influence of electrolysis on degradation of organic dyes in aqueous solutions. Electrolysis is a physically-chemical process, during which - under the influence of direct current - chemical reactions proceed inside the system. By choosing efficient conditions it is possible to achieve fundamental changes in the structure of organic compound’s molecules and on the basis of that for example their gradual degradation. This effect can be used in the process of wastewater treatment. The main task of the thesis is to analyse the influence of variously chosen chemical and physical conditions on the rate of degradation of azo dyes, which is the largest group of organic dyes used in industry and from this reason in great amounts contained both in mill residues and sewage water. Azo dyes have been selected for this experiment for their good solubility in water. Other advantage is that their degradation is accompanied by visible decoloration of the solution and their concentration in solution can be easily determined by UV-VIS spectrometry. Concretely two direct azo dyes - C.I. Direct Blue 106 and C.I. Direct Red 79 - have been chosen. The experiment was carried out in a simple reactor consisted of a bath with a stirrer into which two electrodes were installed and attached to the source of direct voltage. Every series of measurement proceeded at constant current which values were varied in range from 100 mA to 1 000 mA. The electric voltage ranged from 7 V to 22 V. Several samples were taken away from the solution during the experiment and the decrease of dye concentration was evaluated in every series. This evaluation validated the hypothesis that the dyes contained in the solution really degraded. This process was also connected to the expected bleaching of the solution. Decoloration of aqueous solution of dye is caused by disruptions in the structure of the dye molecule which is loosing its characteristic sections that cause colourfulness (a conjugate system of double bonds and presence of appropriate substitutes). A total amount of measured series was 16 with various input conditions (Fe and Pt electrodes, electrolytes NaCl, Na2SO4, and NaNO3 and their different concentrations, different current values) which more or less influenced the rate of degradation of investigated substances. It was found out that the blue dye is more likely to be electrolytically degraded. Chemical structure of its molecules, which is smaller and less branched than molecules of the used red dye, could be the source of that. The greatest degradation of the blue one proceeded at two chosen maximum values of constant current 800 mA and 1 000 mA. It could be assumed that current enhancement through the system induces higher dye concentration decrease. Degradation of the blue dye proceeded faster by using electrodes made of stainless steel than the platinum electrodes. The most suitable electrolyte was shown to be sodium chloride. When higher concentration (or conductivity) of electrolyte was used higher efficiency of degradation process was observed.
|
guest ::
