|
|
Measurement of meteorological variables
Škorpík, Daniel ; Harabiš, Vratislav (referee) ; Chmelař, Milan (advisor)
This bachelor thesis discusses about the basic meteorological variables, especially temperature and airflow. These magnitudes are measured using an anemometer which uses resistive sensors, namely, two thermistors of NTC type that described technology, operations, methods of scanning, sensor placement and implementation of such a device. After that was designed block diagram and circuit diagram. The meter is realized, than we describe the individual components and then is calibrated and tested. In conclusion, it is evaluated for use in medicine.
|
|
|
Study of gas sensing properties of tungsten oxide thin films
Vojík, Jiří ; Mašek, Karel (advisor) ; Ševčíková, Klára (referee)
Purpose of this thesis is a study of gas sensing properties of pure and platinum doped tungsten oxide thin films, which are deposited on a glass substrate. Needed films were prepared by magnetron sputtering method. Chemical composition and morphology of the films were investigated by means of XPS and SEM. It was discovered that prepared films are relatively flat and homogenous. They consist of polycrystalline WO3. It emerged that platinum which is present in modified films is in form of the PtO2 and PtO oxides. During subsequent heating of the films in air, which is needed for right function of films as sensors, PtO2 partially reduced. The resistance of the films decreased after heating. Sensing properties of the films were studied at 300 řC. The platinum doped film was more sensitive to exposition of hydrogen than the pure film.
|
|
|
Measurement of meteorological variables
Škorpík, Daniel ; Harabiš, Vratislav (referee) ; Chmelař, Milan (advisor)
This bachelor thesis discusses about the basic meteorological variables, especially temperature and airflow. These magnitudes are measured using an anemometer which uses resistive sensors, namely, two thermistors of NTC type that described technology, operations, methods of scanning, sensor placement and implementation of such a device. After that was designed block diagram and circuit diagram. The meter is realized, than we describe the individual components and then is calibrated and tested. In conclusion, it is evaluated for use in medicine.
|
guest ::
