|
|
Influence of Al ionts in nickel hydroxide on behaviour of electrodes
Růžička, Tomáš ; Vrbický, Jiří (referee) ; Sedlaříková, Marie (advisor)
This master's thesis is concerned with the influence of aluminate ions added in various concentrations into the structure of nicel hydroxide that creates Ni-Cd accumulators positive electrode active mass basis nowadays. Nicel hydroxide occurs in two basic modifications ? and ß. Nowadays used ß modification reaches low capacity in comparison with ? modification. The disadvantage of ? modification is its instability and gradual degradation to ß modification. The aim of this diploma paper is to select the optimal amount of aluminate additives into the structure of nicel hydroxide with regard to electrochemical efficiency, stability, and degradation degree of the accumulated layer.
|
|
|
Influence of Mn ionts in nickel hydroxide on behavour electrodes
Cirkovský, Jaroslav ; Vrbický, Jiří (referee) ; Sedlaříková, Marie (advisor)
The aim of my diploma thesis was to explore the influence of manganese ions put into nickel nitrate structure. The attention was focused mainly on the stabilization of nickel nitrate a modification, which could not change into b modification. The theoretical part of my thesis focused on applied materials, kinds of acumulators, basic parameters of acumulators and the description of chosen methods of measurement employed. It contained the electrodeposition, the impedance spectroscopy and the cyclic voltammetry. The task of the experimental part was to measure the effect of manganese ions put into potassium hydroxide structure. Proportions of Ni (nickel nitrate) : Mn (manganese nitrate) 10:0, 7:3, 5:5, 6:1 and 6:4 were blended for the measurement. By means of the electrodeposition, there was a thin layer of nickel hydroxide with an admixture of manganese ions from nickel nitrate and manganese nitrate dilution put on the nickel plate. After the spread of the thin layer on the nickel plate, the measurement by the method of cyclic voltammetry followed. The next task consisted in trying to add KOH (potassium hydroxide) anionic and cationic surfactant into the dilution.
|
|
|
Study of manganeese oxides properties by the EQCM method
Pléha, David ; Špičák, Petr (referee) ; Novák, Vítězslav (advisor)
The present work deals with the use of manganese oxide as a catalyst for positive electrode of fuel cells. The theoretical part is to analyze the problem of fuel cells, focusing on lowtemperature fuel cells. Are discussed and the methods of measurement and evaluation of properties of manganese oxide layer. The practical part deals with doping electrolytic manganese dioxide salts of divalent metals and monitoring their behavior in the cyclic voltammetry by the EQCM method.
|
|
|
Catalysts for positive electrode of hydrogen-oxygen fuel cell
Kováč, Martin ; Bača, Petr (referee) ; Novák, Vítězslav (advisor)
Master's thesis deals with new methods of preparing catalytic materials for positive electrode of an oxygen-hydrogen fuel cell and the influence of potassium permanganate or doping agent molar mass change on theirs attributes. Further it studies the use of proper measuring methods designed to qualify theirs attributes and the presentation of achieved results. In particular methods of linear sweep and cyclic voltammetry and the processing of data using Koutecky-Levich and Tafel plot and wave log analysis. Values of half-wave and onset potential and kinetic coefficient have been measured and calculated.
|
|
| |
|
|
Carbon based electrodes for supercapacitors
Moncoľ, Maroš ; Kunovjánek, Miroslav (referee) ; Dvořák, Petr (advisor)
This master thesis deals with supercapacitors based on electrical double layer and proper carbon electrodes for this type of supercapacitors. In theoretical part of work is described theory of supercapacitors, energy storage principles and their properties. In the next part are described carbon materials, their properties and electrochemical methods of measurements that we used. In the experimental part is described preparation of electrodes, results and conclusion.
|
|
|
Electrochemical sensor array
Šulc, Jakub ; Prášek, Jan (referee) ; Adámek, Martin (advisor)
In recent years (Of late year)microelectronic technology significantly affected in the field of sensor technology, especially in the field of electrochemical sensors. This thesis deals with design and construction of thick-film voltammetric sensors array. The reason for proposal of voltammetric sensors array is to increase of speed, increase the accuracy and extension possibilities measurement compared with common systems.By reason of increase of sensitivity of these sensors it is efficient use the potentiostat chip for measurement output signal. Created sensors must fulfill the specified parameters and also requirements of thick-film technology. Next step is design the basic blocks of electronic circuit used to evaluate the measured values.
|
|
|
Properties electrodes materials for alcaline accumulators
Řihák, Lukáš ; Vrbický, Jiří (referee) ; Sedlaříková, Marie (advisor)
This thesis is involved in basical properties of electrode materials for alkaline accumulators. This thesis describes the possibilities of capacity stabilisation of nickel electrode to be stable for highest number of cycles. Thesis also consider modification of properties of electrode materials on the base of nickel hydroxide by using dopes (aluminum, manganese). Measuration proceeded on the thin film electrodes created by electrodeposition. Measuration of properties of electrodes proceeded by cyclic voltammetry and frequency analyzis.
|
|
|
The influence of alcaline accumulators loading on their parameters
Čech, Ondřej ; Vrbický, Jiří (referee) ; Sedlaříková, Marie (advisor)
This master's thesis deals with alkaline battery characteristics and it has special consideration of nickel-cadmium cells. There are three main experimental parts in this paper. First one is concerned with positive electrode materials properties and is aimed to investigate impact of magnesium ions formed into nickel hydroxide electrode structure. Second part deals with battery charging/discharging and response measurement tool design. National Instruments hardware PXI modules for data acquisition was used and program in LabView environment was made. Last one is concerned with nickel-cadmium cell properties changes during increased temperature stressing. Investigation of cell self-charge changes during lithium hydroxide addition into electrolyte was made.
|
|
|
Investigation of intercalation of alkaline metals in electrochromic devices
Kortyš, Petr ; Špičák, Petr (referee) ; Svoboda, Vít (advisor)
This work deals with investigation of intercalation of alkaline metals in electrochromic devices by the help of the quartz crystal microbalance method. The general aim is to investigate the influence of molar mass and resistance on properties of vanadium pentoxide and tungsten trioxide electrochromic films. The main measuring method used for investigating of interacalation of sodium and lithium ions into these films is the cyclic voltammetry. Drawn graphs reveals that sodium and lithium ions shows different qualities during intercalation, particularly in participation of solvent, therefore, in the influence of molar mass and in structural changes in the films.
|
guest ::
