|
|
Vliv raného termínu odlistění zóny hroznů na kvalitu a zdravotní stav u bílých odrůd révy vinné
Pavlíková, Romana
This bachelor work focuses on timing, intensity and influence of defoliation on quality and physiology of grapevines. In the introduction, brief history of defoliation and mechanical devices used for defoliation are discussed. The main part describes an experiment testing different defoliation timing on Riesling grape quality. At the end of the main part, statistical analysis is presented. The experiment was done in the Mendel university vineyard, in Lednice, in the year 2015. In the end of the work, implications for planter praxis are discussed.
|
|
|
Preparation and characterization of epitaxial tungsten oxide thin films
Pavlíková, Romana ; Mašek, Karel (advisor) ; Olejník, Kamil (referee)
Tungsten oxide thin films were prepared by vacuum evaporation on surfaces of Pd(111), Cu(111), Cu(110) and Cu(100) single crystals and studied by RHEED, XPS and AFM methods. The tungsten oxide deposition was done at temperatures from 300 řC to 400 řC in UHV or in oxygen atmosphere. The best deposition conditions - substrate temperature of 400 řC and oxygen atmosphere - were found resulting in growth of epitaxial and only partially reduced thin films. Thin films grown on the Pd(111) and Cu(111) surfaces consisted of two phases: a nearly atomically flat phase with (100) epitaxial plane and a phase formed by three dimensional particles with (111) epitaxial plane. Thin film deposited on Cu(100) also consisted of two phases: a flat film with (100) epitaxial plane and self-organised 1D structures parallel to Cu[010] and Cu[001] directions. Thin film prepared on the Cu(110) surface contained solely 1D structures parallel to Cu[1-10] surface direction. Capability of the partially reduced thin films for oxidation was studied. We applied oxidation using RF oxygen plasma, O2 exposure at elevated temperature and exposure to atmosphere. Thermal stability of the WO3/Cu(110) system was also investigated by heating up to 620 řC.
|
|
|
Study of influence of the substrate temperature on the structure of epitaxial tungsten oxide layers
Pavlíková, Romana ; Mašek, Karel (advisor) ; Veltruská, Kateřina (referee)
Purpose of this thesis is a study of substrate temperature influence on structure, chemical composition and morphology of tungsten oxide thin films prepared by oxidation of a tungsten single crystal W(110) using a radio frequency plasma source. Thin film's parameters were observed by RHEED, XPS, AFM snad SEM. The substrate was oxidized at room temperature (RT) and at temperatures of 400ř C, 500ř C and 550ř C. In the first and the second case, produced thin films were amorphous and epitaxial structure was obtained by recrystallization. At the temperature of 500ř C, an epitaxial thin film was produced directly. After further heating at the temperature of 550ř C we got polycrystalline thin film without orientation of the crystal grains. All the epitaxial thin films had (111) crystallographic plane parallel to substrate surface. The tungsten oxide layers grew with relatively hight surface roughness in the order of several nanometers.
|
guest ::
