Original title:
Povrchové vrstvy slitiny se střední a vysokou entropii připravené metodou cold-spray
Translated title:
Surface coatings of medium and high entropy alloy prepared by the cold-spray method
Authors:
Vražina, Tomáš ; Adam, Ondřej (referee) ; Moravčík, Igor (advisor) Document type: Bachelor's theses
Year:
2020
Language:
cze Publisher:
Vysoké učení technické v Brně. Fakulta strojního inženýrství Abstract:
[cze][eng]
Bakalářská práce se zaobírá výzkumem vrstvy slitiny CoCrNi nanesené na substrátu austenitické korozivzdorné oceli pomocí metody cold-spray. Hlavním úkolem byla charakterizace nástřiku a analýza jeho mikrostruktury před tepelným zpracováním a po něm. Práce je rozdělena do dvou hlavních částí. Teoretická část poskytuje všeobecné informace o výrobě a vlastnostech slitiny a způsobu její depozice. Praktická část zprostředkovává snímky z elektronové mikroskopie, EDS analýzy a analýzu porozity spolu se zkouškami mikrotvrdosti. Z výsledků bylo zjištěno, že deponovaná vrstva byla stabilní a nedocházelo zde k odtrhávání deponovaného materiálu od substrátu. Povlak vykazoval nízkou hodnotu porozity, která byla později snížena tepelným zpracováním. EDS analýzou bylo také prokázáno, že povlak nebyl úplně homogenní. Závěr shrnuje výsledky dosažené v praktické části.
This bachelor thesis investigated coating of the CoCrNi (Medium entropy) alloy deposed onto austenitic steel substrate. The main objectives were characterization and analysis of sprayed deposition before and after heat treatment. The thesis was divided into 2 main parts. The theoretical part provided general information about alloy manufacturing, properties, and the method of its consolidation. The experimental part provided electron microscopy analysis including, an EDS, a porosity analysis and microhardness testing. Its results were then discussed on the base of the information gathered in the theoretical part. The results showed that the deposed layer was stable and there was no sign of material decohesion. The coating showed low porosity which was later successfully lowered by heat treatment. EDS proved that the coating was not entirely homogenous. The conclusion summarized the results achieved in the practical part.
Keywords:
coating; coldspray; Highentropy alloy; mechanical alloying; porosity; coldspray; mechanické legování; porozita; povlak; Slitina s vysokou entropii
Institution: Brno University of Technology
(web)
Document availability information: Fulltext is available in the Brno University of Technology Digital Library. Original record: http://hdl.handle.net/11012/191791