TY - THES TI - Svařování rámu dvojkola TT - Welding the frame of the tandem bicycle AU - Rajm, Vojtěch AB - In the first part of thesis were compared frames of two different bicycles and according to this comparison was designed a geometry of tandem bicycle. In a next part were described the most common materials in cycling industry and theirs advantages and disadvantages. According to the comparison, the steel EN 25CrMo was considered as the most suitable material for its low prize and high strength. After that is described weldability of steels and types of cracks which are one of the most casual defects in welded materials. In another part of thesis are theoretically described kinds of suitable welding methods for bicycle frames. As the most suitable are methods in shielding gases MIG/MAG and TIG. As the best method was chose TIG welding. In a practical part of thesis are compared these methods experimentally. Tubes from selected material were welded by MAG and TIG. The TIG welding proved again as better because of deeper and tough welds. AB - V první části práce byly porovnány rámy dvou kol a podle nich byla navržena geometrie dvojkola. V další části práce byly popsány nejběžněji používané materiály v cyklistice a jejich výhody a nevýhody. Po porovnání byl vybrán jako nejvhodnější materiál ocel EN 25CrMo4 a to hlavně kvůli nízké ceně a velké pevnosti. Dále je popsána svařitelnost ocelí a druhy trhlin, což jsou jedny z nejčastějších defektů ve svařovaném materiálu. Dále se práce zabývá popisem vhodných metod svařování v oblasti rámů kol. Jako nejvhodnější se jeví metody svařování v ochranných atmosférách MIG/MAG a TIG. Z nich bylo vybráno jako nejlepší svařování TIG. V praktické části jsou tyto metody svařování porovnány experimentálně. Trubky z vybraného materiálu byly svařeny metodou MAG a TIG. Jako nejlepší se opět ukázala metoda TIG kvůli hlubším a houževnatějším svarům. UR - http://www.nusl.cz/ntk/nusl-417013 UR - http://hdl.handle.net/11012/192241 A2 - Sigmund, Marian A2 - Kubíček, Jaroslav LA - cze KW - Geometrie rámu kola KW - svařitelnost ocelí KW - Geometry of bicycle frames KW - tandem bicycle KW - TIG welding KW - dvojkolo KW - weldability of steels KW - svařování TIG PY - 2020 PB - Vysoké učení technické v Brně‎, Antonínská 548/1, 601 90 Brno, http://www.vutbr.cz/ ER -